ROBINHOOD IC 300 Deluxe User manual

1
Description: ROBINHOOD IRONING CENTRE
Model Number: IC300/200/100
Model pictured: IC300
107734
Issue: E
SPECIFICATION DIAGRAM
Model
IC 300 Deluxe
IC 200 Executive
IC 100 Standard
All dimensions in mm
Model may vary slightly from images pictured

2
Overview
Contents of packaging:
1 x Robinhood Ironing Centre
1 x Installation kit (incl screws..)
1 x Door (incl handle)
Pre-installation
Important:
oPlease read the entire instructions before installing the Ironing Centre.
oRobinhood Ironing Centre can be mounted in two ways: Recessed Mount and Surface Mount. For Surface Mount
an additional decorative collar can be purchased (Product Code ICMC).
oRemove the Packing Stops with the small flat screwdriver from the Ironing Board assembly (only on Deluxe).
oAscertain from the user the DESIRED HEIGHT of the Ironing Board when in the open position.
oWe recommend an ironing surface height of 830mm above the floor for an average adult. To obtain this surface
height, the height of the unit (see diagram below) must be 680mm above the floor.
oFor Deluxe, 830mm is based on the second or middle position of the ironing board.

3
Mounting the Ironing Centre
SURFACE MOUNT OPTION
oMake sure sold timber studs or mounting points are in suitable position for the mounting of the ironing centre.
oDrill through the back of the cabinet and fasten the six screws supplied (it may be necessary to purchase
different length screws for correct fitting, or use wall anchors if unit is to be mounted to solid wall.)
NOTE: Collar Kit Product Code ICMC) is also available.
RECESS MOUNT OPTION
1. SIZE OF WALL OPENING
The Ironing Centre is designed to fit between 362mm studs. Take out a section of the wall and insert two timber
studs vertically at 362mm apart.
2. ATTACH BRACE
Attach horizontal brace between the studs at the desired height. Ensure that the brace is level.
3. MOUNT CABINET
Lift cabinet into place, rest the cabinet on horizontal brace, plumb and shim cabinet to fit, and attach to studs
using the supplied screws. Mounting hole positions are indicated by the arrows. On the Electric models, remove
the wireway cover to access mounting hole. Be sure to allow for wall covering thickness behind cabinet face
frame.

4
Connecting the Ironing Centre to Electric Power
oFor recessed mount, an external ON/OFF (safety) switch for the Ironing Centre must be installed near the unit.
An additional power socket can be installed inside the wall between the switch and power plug.
oAlternatively the unit can be hard wired directly to the switch by an electrician.
oFor surface mount, the Ironing Centres’ plug and lead can be easily plugged into a nearby wall socket, or can
be hard wired by an electrician.
Door Assembly Instructions
1. Mounting the Cabinet Door
oDoor may be hinged from either side of the cabinet (illustration is shown for right side hinging).
Both sides of the cabinet have pre-punched holes.
oUse the two hinges supplied to fix door to the cabinet.
oAttach the hinges to door and cabinet using the screws supplied at the top and bottom section of
the cabinet.
oUse the decorative plugs supplied to cover the unused pre-punched holes.
2. Fixing Magnetic Catch
oMagnetic catch is fixed opposite to the hinge.
oFixing position is located on the top section of the cabinet and the door.
oAttach the magnetic catch 2A onto cabinet using the screws supplied.
oAttach the strike plate 2B onto door using the screw supplied.

5
1. Disconnect Ironing Centre from power supply. Ensure the power is switched off.
2. Insert small screwdriver or slim knife as shown, ease catch to side and slip out diffuser.
3. Replace lamp (40 watt max.)
4. Slide diffuser back into aperture and “click” into place. Turn power back on.
Operating Instructions
To open the Ironing Board, lift board retainer and lower the board. To store Ironing Board, follow the steps in
reverse order.
On DELUXE Model.
The Ironing Board has three working heights, to adjust the board:
1. With the board in the horizontal position hold the board with one hand near the base (NOT BY THE
NOSE) and support the pivot rod with the other hand.
2. Adjust the Ironing board to the desired position by lifting the board (NOT BY THE NOSE) and moving it
to the path of height adjust bracket.
NOTE: In order to store the Ironing board, it must be on its lowest position.
Lamp Replacement

6
Ironing Centre Features
All Robinhood Ironing Centres have the following
features:
oSurface or recess mountable
oUtility shelf for spray bottle storage
oHeat resistant shelf for iron storage
oIntegrated cotton coated rayon cover
oRight or left hand
oMagnetic door catch opening door
oRound corners board
In addition to these standard features
Executive Model IC 200
oBuilt in 230-240 volt power outlet
o40 watt light
oAuto timer
Deluxe Model IC 300
oBuilt in 230-240 volt power outlet
o40 watt light
oAuto timer
o3 level height adjustable
oBoard Swivels a full 180°.
Maintenance
YOUR IRONING CENTRE BOARD IS NOW FITTED WITH A HEAT RESISTANT COVER.
TO AVOID DAMAGE TO THE MATERIAL
PLEASE DO NOT WASH THE COVER
The laminated surface of the unit may be
wiped clean with non abrasive household cleaner.
WARNING
1. Do not place EXCESSIVE WEIGHT (weight should not exceed 15kg) on the Ironing Board when opened
as it is designed to accept normal ironing use only.
2. Iron not to exceed 2000 Watt.
3. Allow iron to cool down before storing in the cabinet.
4. Empty water reservoir and turn off steam action prior to storing iron.
5. Turn power off when not in use.
6. Do not remove the board retainer.
7. The appliance is not intended for use by young children or infirm persons without supervision.
8. Young children shall be supervised to ensure that they do not play with the appliance.
9. The appliance is supplied with an approved power cable which must not be changed. If the supplied cord
of this equipment is damaged, it must only be replaced by the manufacturer, its service agent or similarly
qualified person in order to avoid hazard.
10. Upon installation, ensure that the socket outlet (for Surface Mount) or ON/OFF switch (for RECESSED
MOUNT) remains easily accessible after installation.
Model IC 300 shown

7
Warranty Certificate (New Zealand)
The benefits conferred hereunder are in addition to all other rights and remedies in respect of the product which the purchaser has by virtue of the Consumer Guarantee
Act and similar legislation, and nothing contained in this Certificate shall in any way limit the purchaser's rights under such legislation.
Terms and Conditions
The following conditions apply in respect of the warranty given in this certificate:
1. Robinhood warrants this product against manufacturing defects and faulty materials for a period of:
2. Rangehood –24 months from date of original purchase.
3. Supertub –Lifetime on stainless bowl, 5 years on single lever unit, 1 year on other components from date of original purchase.
4. Ironing Centre –12 months from date of original purchase.
5. Uniduct –12 months from date of original purchase. For commercial use 3 months from date of original purchase.
6. This warranty is limited to the repair or replacement free of charge within the warranty period of any component part which Robinhood at its discretion determines to
be faulty. Such warranty is subject to terms and conditions set out below.
7. The warranty applies within New Zealand.
8. The customer must produce the original invoice or other purchase documentation as proof of the purchase date.
9. To abide by the guarantee please complete the details below and keep it with your purchase invoices.
10.In the event that service is required, contact the source from whom the product was purchased. It will be the responsibility of that sales agent to direct the purchaser
to an authorised service centre or replace the defective parts. All costs of labour performed outside an authorised Service Centre will not be the responsibility of
Robinhood. Alternatively contact Robinhood.
Warranty exclusions
1. The warranty does not apply for the following:
If defect is caused by misuse, wear and tear, dirt, fire or accidental damage.
If the product has been repaired or serviced by an unauthorised person.
If installed contrary to Robinhood instructions.
Products purchased overseas or not designed for use in New Zealand.
Normal user adjustments or customer instruction on the product’s operation.
Abnormal product performance as a result of incorrect installation or deviation from specified instructions.
All costs incurred on installation or removal.
If the product is used outdoors.
2. A charge shall be made if the service person finds the product is functioning correctly.
3. Paint finishes and the colours in plastics are fully covered by this warranty for 12 months from date of purchase.
Should service be required please contact the store where you purchased your Robinhood product. If you require any further advice or information on Robinhood product
feel free to contact:
Robinhood
Free Phone: [phone]
Free Fax: [phone]
Email: [email protected]
Website: www.robinhood.co.nz
Name of purchaser
Address
Date of purchase
Model number
Serial No/Date stamp
Name of supplier
Address
Invoice number
Complete these details and keep it with your purchase invoice.
DO NOT POST
New Zealand
Robinhood Ltd
Telephone: [phone]
Facsimile: 0800 276 246
Email: [e-mail]
www.robinhood.co.nz
Australia
Robinhood PTY Ltd
Telephone: [phone]
Facsimile: 1800 628 577
Email: [e-mail]
www.robinhood.com.au

8
Warranty Certificate (Australia)
The benefits conferred hereunder are in addition to all other rights and remedies in respect of the product which the purchaser has by virtue of the Trade Practices Act
1974 and similar State and Territory legislation and nothing contained in this Certificate shall in any way limit the purchaser's rights under such legislation.
Terms and Conditions
The following conditions apply in respect of the warranty given in this certificate:
1. Robinhood warrants this product against manufacturing defects and faulty materials for a period of:
2. Rangehood –24 months from date of original purchase.
3. Supertub –Lifetime on stainless bowl, 5 years on single lever unit, 1 year on other components from date of original purchase.
4. Ironing Centre –12 months from date of original purchase.
5. Uniduct –12 months from date of original purchase. For commercial use 3 months from date of original purchase.
6. This warranty is limited to the repair or replacement free of charge within the warranty period of any component part which Robinhood at its discretion determines to
be faulty. Such warranty is subject to terms and conditions set out below.
7. The warranty applies within the Commonwealth of Australia.
8. The customer must produce the original invoice or other purchase documentation as proof of the purchase date.
9. To abide by the guarantee please complete the details below and keep it with your purchase invoices.
10.In the event that service is required, contact the source from whom the product was purchased. It will be the responsibility of that sales agent to direct the purchaser
to an authorised service centre or replace the defective parts. All costs of labour performed outside an authorised Service Centre will not be the responsibility of
Robinhood. Alternatively contact Robinhood or your nearest Service Agent as listed below.
Warranty exclusions
1. The warranty does not apply for the following:
If defect is caused by misuse, wear and tear, dirt, fire or accidental damage.
If the product has been repaired or serviced by an unauthorised person.
If installed contrary to Robinhood instructions.
Products purchased overseas or not designed for use in New Zealand.
Normal user adjustments or customer instruction on the product’s operation.
Abnormal product performance as a result of incorrect installation or deviation from specified instructions.
All costs incurred on installation or removal.
If the product is used outdoors.
2. For warranty service outside of Capital City metropolitan area or 30 km from nearest authorised service agent the purchaser shall be liable for travelling expenses and
cost of transport of the product or parts to and from the Service Agent
3. Paint finishes and the colours in plastics are fully covered by this warranty for 12 months from date of purchase.
4. A charge shall be made if the service person finds the product is functioning correctly.
Should service be required please contact the store where you purchased your Robinhood product. If you require any further advice or information on Robinhood product
feel free to contact:
Robinhood
Free Phone: [phone]
Free Fax: [phone]
Email: [email protected]
Website: www.robinhood.com.au
Area
Service agents
Contact details
Victoria
J.A. Appliances
Tel: [phone] Fax: [phone]
Email: jaapp[email protected]
New South Wales (Sydney, North Coast)
All General White Goods Services
Tel: [phone] Fax: [phone]
Email: [email protected]m.au
New South Wales (Country, Wagga Wagga)
K J Wardens
Tel: [phone] Fax: [phone]
ACT
K J Wardens
Tel: [phone] Fax: [phone]
Tasmania
BSH Electrical Pty Ltd
Tel: [phone] Fax: [phone]
South Australia
Ivesons Electrical
Tel: [phone] Fax: [phone]
Western Australia
J.H. Wilberforce
Tel: [phone] Fax: [phone]
Queensland
Terry Hayes Agencies
Tel: [phone] Fax: [phone]
Email: in[email protected]
Name of purchaser
Address
Date of purchase
Model number
Serial No/Date stamp
Name of supplier
Address
Invoice number
Complete these details and keep it with your purchase invoice.
DO NOT POST
ECN: 07034
ECN: 07034
New Zealand
Robinhood Ltd
Telephone: [phone]
Facsimile: 0800 276 246
Email: enqui[email protected].nz
www.robinhood.co.nz
Australia
Robinhood PTY Ltd
Telephone: [phone]
Facsimile: 1800 628 577
Email: enqui[email protected].au
www.robinhood.com.au
ECN: 08 098