WARNING: In order to limit accidents such as electric shocks or personal injury, and in order to limit material damage due to misuse of the
appliance, please read these instructions carefully and follow them strictly. Reading the operating instructions will help you get to know your
appliance and enable you to use the equipment correctly. Please read these instructions in their entirety and make sure that anyone else who may
use the appliance also reads them beforehand.
UNPACKING
• WARN NG - some of the tools are very sharp e.g.
blades, etc..
INSTALLATION
• We recommend that you install your appliance on
its wall frame.
CONNECTION
• Always check that your mains supply corresponds
to that indicated on the identification plate on the
motor unit and that it can withstand the amperage.
• Never plug your appliance into the mains supply
before placing it inside the preparation bowl.
HANDLING
• Always take care when handling the blades, as
they are extremely sharp.
ASSEMBLY PROCEDURES
• Follow the various assembly procedures carefully
(see page 8) and make sure that all the attachments
are correctly positioned.
USE
• Never try to override the safety systems.
• Never insert an object into the preparation.
• Never switch the appliance on unless it has been
placed in the preparation bowl.
• Before dismantling the foot, bell or whisk always
check that the power mixer is unplugged.
• We recommend that you tilt the appliance at
a slight angle to prevent the bell from touching the
bottom of the container.
CLEANING
• As a precaution, always unplug your appliance
before cleaning it.
• Always clean the appliance and its attachments at
the end of each cycle.
• Never immerse the motor unit in water.
• For parts made from aluminum, use cleaning fluids
intended for aluminum.
• For plastic parts, do not use detergents that are too
alkaline (e.g., containing too much caustic soda or
ammonia).
• Robot-Coupe can in no way be held responsible
for the user’s failure to follow the basic rules of
cleaning and hygiene.
MAINTENANCE
• Before opening the motor housing, it is absolutely
vital to unplug the appliance.
• Check the seals and washers regularly and ensure
that the safety devices are in good working order.
• t is particularly important to maintain and check the
attachments since certain ingredients contain corrosive
agents, e.g. citric acid.
• Never operate the appliance if the power cord
or plug has been damaged or if the appliance fails to
work properly or has been damaged in any way.
• Do not hesitate to contact your local Maintenance
Service if something appears to be wrong.
WARNING
Procedure to follow hould the tick blender
become accidentally immer ed during u e.
1) Do not touch the blender, the container, or
the worktop.
2) Unplug the blender from the wall ocket.
3) Lift the blender out of the preparation.
4) Tilt the blender to allow a much of the li-
quid to drain out a po ible.
5) Do not witch the blender back on, a there
i till a ri k of electric hock.
6) The blender mu t be ent to a Robot-Coupe-
approved after- ale ervice o that the
electric part can be properly cleaned and
dried.
IMPORTANT WARNING WARNING
KEEP THESE INSTRUCTIONS
IN A SAFE PLACE
