Robotina HIQ BC-WE-F1 User manual

USER MANUAL
RELAY SWITCH BC-WE-F1
Power supply: 230V AC 50Hz
Switching capabilities: 230V AC –3A
Consumption: < 1W
Max. Engine Power: 280W, 60Nm Max
Radio frequency range: 868.0 to 868.6 Mhz
RF power Max: +3dBm
Range: up to 30m indoor
Operational temerature: -10°C to 40°C
Protection rating: IP 30
Pairing: up to 22 controllers
EPP (EnOcean Profile): D2-05-00
Dimensions: 40mm x 44mm x 16.9mm
Weight: 34g
Warranty: 2 years
USE CAUTIONS
Never use the device if it is not correctly installed and placed
inside a connecting box in conformity with the current norms.
Keep the product far away from liquids.
INSTALLATION
RELAY SWITCH INPUT/OUTPUT
Each terminal can accept a cable of 2.5mm2maximum, stripped
of 8mm. INSTALLATION DIAGRAM
AUTO-DETECTION OF SWITCH TYPE
After turning the power supply ON, do a single push on the wired
wall switch. The relay switch has an auto-detection system to
automatically detect the type of wired wall switch (rocker or
push-button) wired at the input.
Note: The same configuration is applied for both inputs and .
It is not possible to combine a rocker switch with a push-button.
To perform a new auto-detection, the Relay switch must be
manually reset. (see reset procedure)
CALIBRATION OF THE RELAY SWITCH BC-WE-F1
Two modes
1. From the Relay Switch
2. From the wired wall switch
Put the roller shutter/awning in position up.
This product must be used indoor only
This product is conform to EnOcean radio protocol
Thanks to its small size, the Relay Switch can be installed in a
connecting box or behind the wall switch which controls the
roller shutter or motorized awning.
Note: The Relay Switch
LED blinks green,
meaning the calibration
has well started.

PAIRING PROCEDURE
To add a remote or wall switch or the Soft button (EnOcean
compatible) you must enter the pairing mode, your light must
be switched OFF. Relay must be power supplied.
Two modes
1. From the Relay Switch
Launch the pairing by doing 3 consecutive presses on the relay
switch button. The LED blinks red.
NOTE: if the LED blinks orange during the pairing procedure, it means
that more than 22 controllers are paired. You must remove one
controller to add a new one.
2. From the wired wall switch
Do 3 times the cycle »down-stop«with the wired wall switch.
The roller shutter/awning will rise of 10%.
The roller shutter/awning confirms the pairing by closing
complitely.
UNPAIRING PROCEDURE
Do the same procedure as pairing and takes care of pressing the
button previosly chosen to define the state »up«of your roller
shutter/awning.
RESET PROCEDURE
Relay switch must be power supplied.
1. Press more than 5 seconds on your module`s button. The
LED blinks orange.
2. Press once again the button (short press) to confirm the
reset. If the reset is correct the LED blinks alternatively in
red and green and stays green. Start again if necessary.
3. Your module has now its original settings.
You have now 30 seconds to pair your controller by briefly
pressing on the button of your choice, this one will control
the rise of your roller shutter/awning.
You have now 30 seconds
to pair your Soft button by
doing 5 brief consecutive
presses on the button.
The LED of the relay
switch will blink green
twice, confirming the
pairing.
Put the roller
shutter/awning in
position up.
You have now 30 seconds to pair your controller by briefly
pressing on the button of your choice, this one will control
the rise of your roller shutter/awning.