Content
Please read the instruction carefully before starting yourinstallation.
1. General safety regulation
2. Technical Data
3. Safety mounting requirements
4. Installation
4.1 Measurements
4.2 Performing safety analysis
4.3 Installation instruction
5. Operation instruction
5.1 Setting up
5.2 Max. output power for optional accessories
5.3 Control unit operating modes
5.4 Wiring for optional accessories
5.5 Control unit setting & adjustment
6. Trouble shooting
7. Maintenance
9. Manufacturer information
10. EC Declaration
It might cause damage to property or user injury under
incorrect usage.
It might cause serious injury or death under incorrect usage.
Revision 2017/05
Do not attempt to operate until you have read thoroughly
and understand completely all instructions, rules, etc.
contained in this manual. Keep this manual and review
frequently for continual safe operation.
1.1 In order to maintain the accuracy and performance, the
automatic sliding door must be correctly operated and
installed under favorable environmental conditions.
1.2 Inadequate operation may cause damages to the
automatic sliding door and extreme cases may cause
serious injury to the operator.
1.3 MOTION i series is prohibited to install as security or
storm protected device, in escape route or fire and
smoke doors, it’s designed for indoor use.
1.4 Suitable for door weight 20~80Kgs / single sash.
1.5 Do not allow children to play with the device.
1.6 The appliance is not to be used by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction.
1.7 Frequently examine the installation for imbalance and
signs of wear or damage to cables, rollers, and all other
mounting accessory etc. . Do not use any components if
repair or adjustment is necessary.
1.8 Disconnect the power supply before installation, cleaning
or other maintenance. If the system is connected to the
cable comes directly from the wall, ensure the power
supply is de-energized.
1.9 The installer must to check that the temperature range
marked on the device is suitable for the location.
1.10 Before installation, check all components are in good
mechanical condition.
Page 1
