Roca PH-600 User guide

Mounting instruction:
PH-600

PH-600 [Status] P: 2 [3]
2019
-
05
-
22 | 11:12
Roca Industry AB | Radiovägen 19, SE-135 48 Tyresö, Sweden | Tel: [phone] | Fax: [phone] | e-mail: [email protected]
www.rocaindustry.com
Guide for Pull handle with threads
1. Attach the decor washer and the
plastic washer.
2. Use the plastic tube if the handle is
mounted in a glass door.
(Cut the screw to desired length if
necessary)
1. Place the plastic washer between
the glass and head of bolt.
2. Pass the bolt through the door and
start tighten it.
3. Repeat same procedure at the
other end of the tube.
Tighten the bolts, making sure the handle
is stuck and does not slip or rattle.

PH-600 [Status] P: 3 [3]
2019
-
05
-
22 | 11:12
Roca Industry AB | Radiovägen 19, SE-135 48 Tyresö, Sweden | Tel: [phone] | Fax: [phone] | e-mail: [email protected]
www.rocaindustry.com
Guide for Pull handle with set screws
1. Attach the plastic washer, decor
washer and threaded insert (pull
handle side).
2. Bolt and plastic washer on
opposite side.
3. Use the plastic tube if the handle
is mounted in a glass door
Tighten the upper and lower bolt
and make sure the bolts doesn’t slip
or rattle.
Losen the set screws before placing the
handle.
Tighten the set screws and enjoy the
handle