
INSTRUCTION MANUAL
ASSEMBLY, INSTALLATION, USE AND MAINTENANCE.
Rev. 03/2012
Rocam Losi s.r.l. declines every responsibility on any print and/or transcription mistake contained in this booklet
Rocam Losi s.r.l. can change features and datas of this booklet with the proposal of keeping on increase the quality of its products.
Anytime and without notice, this booklet can’t be considered as contract with third parties.
4. Settings
This item is packed and shipped assembled. The manufacturer declines every
responsibility of damage of someone or something caused by the failure to comply with the
instructions of this manual.
Do not make any structural change to the trolley.
The elements composing the trolley (plastic, polyurethane foam, bubbole wrap,
Styrofoam, cardboard and so on) must be kept away from children as potential
sources of danger and must be collected and disposed off separately in
accordance with local regulations.
The manufacturer declines every responsibility of damage of someone or something
caused by the failure to comply with the instructions of this manual.
After the unpacking of the item from its packing, proceed by removing the adhesive
plastic tape before sarting up the product. Any residual glue has to be removed carefully
(do not use abrasive cleaners).
The device is designed to run on AC to the voltage specified on the technical data
plate (located on the bottom of the tank).
The grounding line is marked by the colours yellow/green and must not be
interrupted.
The device is provided with a cable in accordance with the CE regulations and with
has CE and schuko plug (that can be replaced, when necessary, with a different plug,
suitable for the specified wattage and in accordance to the current regulations and
guidelines; when necessary, replace the provided cable with a new one with the same
features).
Before switching the appliance
•Check if the electrical system can withstand the appliance’s load (WATT as indicated
on the techical plate)
•Make sure that the electrical system is provided with ground connection according to
the current norms and guidelines.
•Connect the appliance with the ground network through a cable connected to the
specific screw placed on the external casing of the appliance (See Component n°15
page. 6).
4.1 Appliance Start Up
Once ready to switch on the appliance, plug the device in the electrical system and
press the power switch placed on the compressor front grid.
You will hear a soft buzzing coming from the compressor and the thermostat display
will show the starting temperature of the device.
Once started up, the appliance reaches the selected temperature in about one hour
(it depends much on the starting temperature, the room temperature and the exposure of
the buffet trolley).
The thermostat is set from the manufacturer on +2°C for a optimal use of the
device. Use the attached instructions to change the settings of the digital thermostat.