Rock-Slide Engineering BD-SS-200-JK4 Service manual
1
Next Gen Step Slider
---
TOOLS REQUIRED FOR INSTALL
Congratulaons on your purchase of the Next Gen Step Slider!
AX-SS-SP-JK4
-
•
•
•
•
•3/16”
•3/4”
•1/8”
•5/16” - 18
•
-
---
-
2
PARTS LIST
5/16”
5/16” 1” - 18
5/16” - 18
---
5/16”
5/16”
5/16”
-
3
DRIVER SIDE WIRE COLOR PASSENGER SIDE WIRE COLOR
ORANGE/YELLOW GREEN/GRAY
ORANGE/PURPLE BLUE/WHITE
BROWN/TAN PINK/TAN
RED/BLACK RED/BLACK
WIRING HARNESS
-
4
Step Install
Loosen
NOT
not
’
1/8”
17/32” 1/2”).
5/16”
5/16” 5/16”
-
3/16”
-
5
-
-
If you are having trouble pushing the
harness through, use a hard metal wire
and poke it through the hole as a guide
3/4” 3/4”
-
Do not
ROCK-SLIDE ENGINEERING
6
**Refer to wiring diagram for color code per door**
Run the passenger portion of the harness along the rear driver side
panel, behind the rear seat, to the passenger side. Leave the 18 pin
connector under the rear passenger seat. Run the green/grey wire
Toward the b-pillar on the passenger front. Leave blue/white wire
near the rear passenger door jam.
Pull back the carpet behind the driver side. Locate hole
to run the motor wires.
Remove plug from hole.
Drop the motor wire and light
wires through the hole.
Slit the plug so the plug
sits around the wire.
Repeat on the driver
side of the vehicle.
route remaining harness under
rear seat towards
the driver side
Install door sensors (# 12) . Clean under the door latch hook with an
alcohol swab and put double sided tape on, then attach sensor. Do
this to all 4 doors. Ensure wire faces inside the jeep.
Working on front passenger side, tuck the
Green/gray wire under panels and secure. Connect
Green/gray wire to front door sensor. Secure wires.
Working on the rear passenger,
pull back the carpet and run blue/white
connector towards latch. Connect
door sensor to blue/white.
Repeat the previous step on the driver side front door using the
orange/yellow wire. Ensure wires are tucked away and
do not interfere with seatbelt mechanisms. Connect sensor to the
harness.
Install sensors into harness rear doors using orange/purple on the
driver side.
With the door sensors all connected and installed, we will install the
motor section of the harness. Ensure the motor wires have been run
through the plug and are hanging loosely below the jeep. Run motor
wires and light wires toward the rear of the jeep. Cover wires with
wire loom. Connect motor wire to harness.
Install light kit onto the step slider (Optional—SL-LK-LED). Put magnets onto the door in location shown on all four of the
doors. Door location may vary slightly against sensor location.
Plug circuit board into the harness. Re-install fuse into the harness. Turn on the switch.
Steps should deploy at this me. If they do not deploy see trouble-
shoong guide at the end of the instrucons
20 21
22 23
24 25
26 27
28 29
Figure 6.21.1
Figure 6.22.1 Figure 6.22.2
Figure 6.23.1
Figure 6.26.1
Figure 6.27.1
Figure 6.28.1
-
7
-
Troubleshoong
-
--
-
8
TROUBLESHOOTING YOUR STEP SLIDERS:
I just installed my steps and they aren’t coming down when I open the door.
My switch is geng power but the light stays on in both posions.
Will
this kill my baery with the light constantly lit?
Everything is plugged in and the switch is turning on and o, but sll the steps won’t deploy.
-
-
I tested the motor, its good. I checked the sensors individually, and the system sll won’t work. The steps don’t even deploy unless I do it
manually with 12V power.
The steps deployed and won’t retract. What is going on?
’
I opened my door a bunch of mes and the system just shut o. What happened?
Everything is working now! But I want to take my doors o and have the steps sll work.
--
I was o-roading, le my system on, someone le the door ajar and I ripped my step o on a rock. What now?
’
-
PRODUCT INFORMATION:
WARNING:
REFUNDS / RETURNS: ’
-
wit
PRIVACY POLICY
SHIPPING DAMAGE
WARRANTY POLICY--
-
not
--
RETURNS’
-
PATENT INFORMATION:
PAT US 9,771,024 B2
PAT US 8,833,781B2
PAT US D718,1955
Rely only on high-grade running boards and step bars on our virtual shelves.
This manual suits for next models
1
Table of contents
Popular Other manuals by other brands
Omega
Omega 21022 Operating instructions & parts manual
Hagen
Hagen Fluval EDGE Series user guide
Timex
Timex BODYLINK SYSTEM quick start guide
unidrain
unidrain MATLINE Construction guide
Mallory
Mallory 3146A Installation instructions manual
Truma
Truma Multivent TBM Operating instructions & installation instructions