Rohnson R-5795 User manual

Hand blender set R-5795
EN
1
Instructions Manual
Hand blender set R-5795
Specifications: 220-240V~50Hz, max900W
Read these instructions for use carefully before you use the appliance and save
them for future reference.

Hand blender set R-5795
EN
2
IMPORTANT SAFEGUARDS
•READ ALL INSTRUCTIONS
•Close supervision is necessary when the appliance is near children.
•Before connecting the hand blender to the power supply, check that the
voltage indicated on the rating label of the appliance corresponds with the
voltage in your home. If this is not the case, contact your dealer and stop
using the hand blender.
•Do not operate any appliance with a damaged cord or plug or after the
appliance malfunctions, or is dropped or damaged in any manner. Return
appliance to the nearest authorized service facility for examination, repair or
electrical or mechanical adjustment.
•Unplug from outlet when not in use, before putting on or taking off parts, and
before cleaning. always disconnect the blender from the supply if it is left
unattended and before assembling, disassembling or cleaning.
•Do not let cord hang over edge of table or hot surface.
•Do not immerse upper part of blender into water as this would give rise to
electric shock.
•Avoid contacting moving parts.
•Keep hands and utensils out of container while blending to reduce the risk of
severe injury to persons or damage to the blender. A scraper may be used
but must be used only when the blender is not running.
•The appliance cannot be used for chopping ice or blending hard and dry
substance, otherwise the blade could be blunted.
•To reduce the risk of injury, never place cutting blade on base without first
putting bowl properly in place.
•Be sure chopper lid is securely locked in place before operating appliance.

Hand blender set R-5795
EN
3
•The use of accessory not recommended by the manufacturer may cause
injuries to persons.
•Do not operate the appliance for other than its intended use.
•This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
•Do not use outdoors.
•Never let the appliance run unattended.
•Take care of potential injury from misuse.
•Care shall be taken when handling the sharp cutting blades, emptying the
bowl and during cleaning.
•Switch off the appliance and disconnect from supply before changing
accessories or approaching parts that move in use.
•Never touch the blades when the appliance is plugged in. The blades are very
sharp.
•If the blades get stuck, unplug the appliance before you remove the
ingredients that block the blades.
•Do not overload the appliance by putting in too much food and do not operate
continuously for more than 30 seconds.
•This appliance is intended to be used in household and similar applications
such as:
−staff kitchen areas in shops, offices and other working environments;
−farm houses;
−by clients in hotels, motels and other residential type environments;
−bed and breakfast type environments.

Hand blender set R-5795
EN
4
DESCRIPTION OF PARTS
BEFORE FIRST USE
•Remove all packaging
•Thoroughly clean the parts that come into contact with food before you use
the appliance for the first time.
•Let hot ingredients cool down before you process them (max. temperature
60°C).
•Cut large ingredients into pieces of approximately 2 cm before you process
them.
A. Variable speed
control
B. Switch button
(Low speed)
C. Turbo button
D. Motor Unit
E. Blender Stick
F. Whisk Gear Box
G. Whisk
H. Beaker-Measuring
Cup
I. Chopper Lid
J. Chopper Blades
K. Chopper Bowl

Hand blender set R-5795
EN
5
•Always place the motor unit on a level surface.
HOW TO USE
Instruction for hand blender
The hand blender is intended for :
−blending luqids, e.g. dairy products, sauces, fruit juices, soups, mixed drinks
and shakes.
−mixing soft ingredients, e.g.
−pureeing cooked ingredients, e.g. for making baby food.
1. Attach the blender bar to the motor unit (Fig.2).
2. Put the ingredients in the beaker.
3. Immerse the blade guard completely in the ingredients(Fig.3).
4. Pressing the normal or turbo speed button to switch on the appliance(Fig.4).

Hand blender set R-5795
EN
6
5. Move the appliance slowly up and down and in circles to blend the ingredient.
Note: Max operation duration per time cannot exceed 15 second and 2 minute rest
time must be maintained at one consecutive cycles.
Caution: Blades are very sharp, handle with care. Ensure that the hand blender is
unplugged from the power outlet before assembling or removing attachments.
Instruction for chopper
•Note: The chopper is intended for chopping ingredients such as nuts, meat,
onions, hard cheese, boiled eggs, garlic, herbs, dry bread etc.
•Attention: The blades are very sharp! So be very careful when handling the
blade unit. Be especially careful when you remove the blade from the
chopper bowl, when your empty the chopper bowl and during cleaning.
1. Put the chopper blade unit in the chopper bowl (fig.5)
2. Put the ingredients in the chopper bowl.
3. Put the coupling unit on the chopper bowl (fig.6).

Hand blender set R-5795
EN
7
4. Fasten the motor unit onto the chopper bowl (fig.7).
5. Pressing the normal or turbo speed button to switch the appliance.
•If the ingredients stick to the wall of the chopper bowl, loosen them by adding
liquid or using a spatula.
•Always let the appliance cool down after chopping meat.
Note: Max operation duration per time cannot exceed 5 second, and 2 minute rest time
must be maintained at two consecutive cycles.
Caution:
−To reduce the risk of injury, never place cutting blade on base without first
putting bowl properly in place.
−Be sure chopper lid is securely locked in place before operating appliance
Instruction for whisk beater

Hand blender set R-5795
EN
8
Use the whisk only for whipping cream, beating egg whites and mixing sponges and
ready-mix desserts.
1. Insert the whisk into the whisk gear box , then insert the motor part into the
gear box until it locks.
2. Place the whisk in a vessel and only then, press switch to operate it.
3. To release, press buttons and pull off the gear box. Then pull the whisk out of
the gear box.

Hand blender set R-5795
EN
9
For best results:
•Do not use the beaker , but a wider bowl.
•Start with a low speed setting.
•Move the whisk by holding it slightly inclined.
•Only whip up to 400 ml chilled cream (min. 30 % fat content, 4–8 °C).
•Only whip up to 4 egg whites
! Warning:
6. Always disconnect the blender from the supply if it is left unattended
and before assembling, disassembling or cleaning;
7. Do not allow children to use the blender without supervision.
Processing guide
Maximum amount
Operate time
Rest time
Beaker: Put the maximum amount until the “MAX” indication on the
beaker (700ml).
15 sec
2 min
Chopper bowl: Put the maximum amount until the “MAX” indication
on the chopper bowl (500ml).
5 sec
2 min
CLEANING AND MAINTANCE
Do not immerse the motor unit and the whisk coupling unit in water.
•Unplug the appliance before cleaning.
•Dissemble all the parts.
•Do not immerse the motor unit into water.
•Wipe the motor unit with a moist doth..
•Clean the beaker, the chopper bowl, the chopper blade unit and the chopper
coupling unit in the dishwasher or in warm water with some washing-up liquid.

Hand blender set R-5795
EN
10
•Dry and store them for future use.
Caution: Blades are very sharp, handle with care.
Quick cleaning:
Between processing tasks, hold the hand-held blender in the cup half filled with water
and turn on for a few seconds.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN
ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban waste.
It must be taken to a special local authority differentiated waste collection centre or to a
dealer providing this service.
Disposing of a household appliance separately avoids possible negative
consequences for the environment and health, deriving form inappropriate disposal
and enables the constituent materials to be recovered to obtain significant savings in
energy and resources. As a reminder of the need to dispose of household appliances
separately, the product is marked with a crossed-out wheeled dustbin.