ROKR LKB01 User manual

The product is for people who include and over 14 years old.
Kids should assemble under the guidance of adults.
Functional sharp point and edge. Use with care. To be used
under the direct supervision of an adult.
1.Keep the product away from the source of ignition and water to prevent any damage.
2.Don't use chemical reagents like alcohol, ammonia water to clean the product.
3.Use clean and soft fabric to clean the product if necessary.
1.Take off the pieces from the board according to each step before assembling,and place them properly in case of missing.
2.According to the instructions whenyou assemble all the pieces.Keep properly the instructions and validated after assembly.
3.Polish the parts with sand paper, enhance aesthetic feeling and gear lubrication.
4.Repair with glue prepared by yourself if the wooden pieces would be break.
5.There are letters on some parts as shown,assemble them together with same etters.
6.Scan the QR code with remind for assembly video.
7.There is a little different from several parts and the pictures on instruction,subject to parts number.
8.There are spare parts on wooden board.
Drawing the attention of the parents to the fact that any safety isolating transformer or charging unit to be
used with the toy should be regularly examined for potential hazard,such as damage to the cable or cord,
plug,endosure of other parts and that in the event of such damage,the toy must not be used until that
damage had been properly removed.
How to solve the fracture of parts?
It's too hard to assemble the parts.
My hands hurt.
The parts are very precise, too hard to install.
1. It is difficult to install the tight fitting parts.
2.No tools were used.
1. Take off the parts carefuly.
2. Looking for spare parts.
3. Glue the broken parts.
1. Check if there are assembly errors.
2. Press the parts with tool i5.
3.Wax the parts.

Shaft Sleeve
Screw
Wax
Screwdriver
Hand screw
Plug
Eyelet
Wooden Stick
Ratchet Wheel
Ratchet
Spring
Steel Ball
O-ring
Item
Number
Illustration
Quantity
P1-P20 parts are in plastic bag 3-1 ,P21-P50 parts are in plastic bag 3-2 .The parts which with the gray backgroup are in the other bags .
Parts List (suggest to put all the parts in a box to prevent loss )

Iron Gasket
Antiskid Tube
Limit Speed
Adjustment
Turntable
Bearing
Control Box
Potentiometer
Knob
Motor
Hexagon Nut
Square Nut
Long Beads
Wire
Turntable
Column
Gramophone
Arm
Pickup
Horn
Steel Ball
Antiskkid Mat
Gramophone
Record
Ensure the connection of
gears smoothly
Polish the parts
with sandpaper
Perspective changed
Wax the gray parts
with remind
Ensure the parts
running smoothly
Assemble the parts
symmetrically
Special attention in
assembly
Step 1
Step 2
Printed side
Blank side
Complete 2
same parts
For example :

Ensure the connection of gears smoothly
Refer to Page 3
Wax the gray parts with remind
Press to
the end
Press to
the end

Printed side
Blank side
A3 is easy to
damage ,take it off
carefully .

F2&F3 is easy to damage ,take them off carefully .

Set aside the thickness of a piece of wood.

Black or Red

Insert the limit speed adjustment turntable to the three screw
holes and press it down. Rotate the turntable and let the speed
adjustment turntable down to the window.
Grinding off edges of the gray part and wax it.
Do not rub cut
A33 and A34
Do not rub cut the parts