Roland S-4000S User manual

S-BP (Blank Panel) Installation Manual
This guide describes how to install S-BP (Blank Panel) in your S-4000S.
Before you attempt installation, please read this document carefully.
©2006 Roland Corporation
All rights reserved. No part of this publication may be reproduced in any
form without the written permission of ROLAND CORPORATION.
When installing or detaching the S-BP, be sure to consult your RSS
Authorized Service Center.
After installing the S-BP, please be sure to return this document to the
purchaser.
• Always turn the unit off and unplug the AC plug
before attempting installation of the S-BP.
• Remove only the specified screws.
• When the S-BP installation is complete,
double-check your work.
• Use a Philips screwdriver of the appropriate size to
avoid damaging the screw heads (a number of 2
screwdriver).
• Turn the screwdriver counter-clockwise to loosen
the screws-turn it clockwise to tighten them.
• Be careful not to let the screws drop inside the each
unit.
• Never leave a module uninstalled. Cover any
unused slots with S-BP blank panels.
• Be careful not to cut your hand on the edge of the
circuit board or the opening edge wile removing the
S-BP.
For the Purchaser — Please Read
For the Installer (Service Technician)
— Please Read
Cautions When Installing the S-BP
tightenloosen

*04232856-01*
04232856 ’06-1-1NS-BP
1Remove the two screws from each module
(SI-AD4 or SO-DA4) installed in the
S-4000S.
2Extract the module from the S-4000S.
3Install an S-BP in the opening left by the
removed module.
4Secure the module in place using the two
screws removed when detaching the
module.
Installing the S-BP to the S-4000S
The module shown
in the figure is the
SO-DA4. The
removal procedures
for the SI-AD4 and
SO-DA4 are the
same.
Extraction of the
SI-AD4 or SO-DA4
may be
accomplished more
easily by inserting
an XLR plug into a
connector on the
module, then
pulling out the
module while
gripping the plug.