Romik 2135 User manual

REV 3 04/15/20
Installation Instructions
Part No. 2135 / 6210
Product: Running Boards
Application:
Ford Escape 2013-2019
Lincoln MKC 2015+
Level of Difficulty: 1
2 3 4 5
Installation Time: 60 min
Hardware
Torque Specifications
M6 Bolt
3 ft-lbs.
M8 Bolt
7 ft-lbs.
M10 Bolt
16 ft-lbs.
M12 Bolt
28 ft-lbs.
ATTENTION: Use correct torque settings to avoid
damaging the running boards and or mounting
brackets. Failure to do so will void your warranty.
If you have any questions please contact our technical
team at 1-866-717-6645

Installation Instructions 2135 / 6210 Bracket Kit
Step 1: Locate front mounting locations and hardware as per 1st page of this installation manual
Step 2: Install provided HTC 230 on both front locations Figure 1. Proceed to install front bracket as shown on
Figure 2. Do not tighten
Step 3: Locate rear bracket mounting area, install provided HTC 243 as shown Figure 3. This is where the
extra support will mount.
Video
Installation
Instruction:
Figure 1
Figure 2
Figure 3

Installation Instructions 2135 / 6210 Bracket Kit
Step 4: Locate main rear bracket mounting area, install provided HTC 243 as show Figure 4.
Step 5: Install extra support as shown on Figure 5. Attach main rear bracket as shown on Figure 6. Connect
extra support to main rear bracket using supplied M10 hardware as shown on Figure 7. Do not tighten
Step 6: Proceed to last page of this manual for running board install instructions and torque values
For Technical support please call our team at 1-866-717-6645 and one of our experts will assist
you with this installation.
Thank you for choosing Romik.
Figure 4
Figure 5
Figure 6
Figure 7

Running Board Installation Instructions
1) Flip your Romik running boards onto a flat surface, make sure to place the running boards on a
towel or cardboard in order to protect the surface Figure 1.
2) Loosen the M8 bolts on back of your running boards Figure 2. Depending on your model there
Will be either 6 or 8 bolts installed per side.
3) Once your brackets have been installed, place the running board onto the brackets as shown on
Figure 3.
4) Adjust running boards, centering on vehicle. Hand tight M8 hardware on running boards.
5) Follow the torque procedures, torque M8 hardware to 7 ft-lbs using a torque wrench.
6) Cleaning and maintaining your running boards is important, apply a light coat of a quality
carnauba wax at least 2X per year. Wash often with mild soap and make sure to remove all soap
Residue. Many car automatic carwashes use a strong soap, make sure to use enough water to
remove all residue.
7) Register your products at www.Romik.com/contact/productregistration
8) Warranty information at www.Romik.com/warranty