Romik 2617 User manual

REV 2 02/25/20
Installation Instructions
Part No. 2617
Product: Running Boards
Application:
Fiat 500X 2015+
Jeep Renegade 2015+
Level of Difficulty: 1
2 3 4 5
Installation Time: 60 Min
Hardware
Torque Specifications
M6 Bolt
3 ft-lbs.
M8 Bolt
7 ft-lbs.
M10 Bolt
16 ft-lbs.
M12 Bolt
28 ft-lbs.
ATTENTION: Use correct torque settings to avoid
damaging the running boards and or mounting
brackets. Failure to do so will void your warranty.
If you have any questions please contact our technical
team at 1-866-717-6645

Installation Instructions 2617 Bracket Kit
Step 1: Locate front mounting locations and hardware as per 1st page of this installation manual
Step 2: Remove factory rubber plug Figure 1, Install HTC 262 as shown Figure 2
Step 3: Locate extra support area Figure 3 Remove factory rubber plug and install provided M6 bolt on metal
lip, bolt will protrude from top to bottom and create a stud for the extra support Figure 4. Install extra bracket
Figure 5.
Step 4: Install main front bracket Figure 6, attach extra suppor to main bracket using supplied M10 hardware
Figure 7. Do not tighten
Step 5: Locate rear extra support area and remove factory plastic retainers Figure 8,9. there are two retainers
opposite to each other remove both. Once removed install M6 hardware Figure 10 and 11
Video
Installation
Instruction:
Figure 1
Figure 2
HTC 262
Figure 3
M6
Figure 4
Figure 6
Figure 7
M10
Figure 5
Figure 8
Figure 9
Figure 10
M6

Installation Instructions 2617 Bracket Kit
Step 6: Install extra support bracket as shown on Figure 12
Step 7: Remove rubber plug for rear bracket area as show Figure 13, Install provided HTC 240 as shown
Figure 15. Attach rear main bracket as shown Figure 16. Attach extra support to main rear bracket using
supplied M10 hardware Figure 17. Do not tighten
Step 8: Proceed to last page of this manual for running board install instructions and torque values
For Technical support please call our team at 1-866-717-6645 and one of our experts will assist
you with this installation.
Thank you for choosing Romik.
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15
Figure 16
Figure 17
M6
HTC 240

Running Board Installation Instructions
1) Flip your Romik running boards onto a flat surface, make sure to place the running boards on a
towel or cardboard in order to protect the surface Figure 1.
2) Loosen the M8 bolts on back of your running boards Figure 2. Depending on your model there
Will be either 6 or 8 bolts installed per side.
3) Once your brackets have been installed, place the running board onto the brackets as shown on
Figure 3.
4) Adjust running boards, centering on vehicle. Hand tight M8 hardware on running boards.
5) Follow the torque procedures, torque M8 hardware to 7 ft-lbs using a torque wrench.
6) Cleaning and maintaining your running boards is important, apply a light coat of a quality
carnauba wax at least 2X per year. Wash often with mild soap and make sure to remove all soap
Residue. Many car automatic carwashes use a strong soap, make sure to use enough water to
remove all residue.
7) Register your products at www.Romik.com/contact/productregistration
8) Warranty information at www.Romik.com/warranty