Romik 2164 User manual

REV 2 10/15/21
Installation Instructions
Part No. 2164
Product: Running Boards
Application: Ford Escape 2020+
Ford Bronco Sport 2021+
Level of Difficulty: 1 23 4 5
Installation Time: 90 min
Hardware
Torque Specifications
M6 Bolt
3 ft-lbs.
M8 Bolt
7 ft-lbs.
M10 Bolt
16 ft-lbs.
M12 Bolt
28 ft-lbs.
ATTENTION: Use correct torque settings to avoid
damaging the running boards and or mounting
brackets. Failure to do so will void your warranty.
If you have any questions please contact our technical
team at 1-866-717-6645

Installation Instructions 2164 Bracket Kit
Step 1: Locate front mounting locations and hardware as per 1st page of this installation manual
Step 2: Install provided HTC 230 and HTC 226 on both front locations Figure 1. Proceed to install front bracket
as shown on Figure 2. Do not tighten (Passenger side shown)
Step 3: Locate rear bracket mounting area, install provided HTC 238 as shown Figure 3. NOTE some models
will require undercarriage panel trimming. Trim as needed.
Video
Installation
Instruction:
Figure 1
Figure 2
Figure 3
HTC 230
HTC 226

Installation Instructions 2164 Bracket Kit
Step 4: Using supplied wire, “pass” special bolt and plate through the large hole coming out of the smaller hole
just above. Install plastic “klips” without letting go of wire to prevent losing the special bolt inside the chassis.
as show Figure 4. Install rear bracket as shown of Figure 5, do not tighten
.
Step 5: Proceed to last page of this manual for running board install instructions and torque values
For Technical support please call our team at 1-866-717-6645 and one of our experts will assist
you with this installation.
Thank you for choosing Romik.
Figure 4
Figure 5

Running Board Installation Instructions
1) Flip your Romik running boards onto a flat surface, make sure to place the running boards on a
towel or cardboard in order to protect the surface Figure 1.
2) Loosen the M8 bolts on back of your running boards Figure 2. Depending on your model there
Will be either 6 or 8 bolts installed per side.
3) Once your brackets have been installed, place the running board onto the brackets as shown on
Figure 3.
4) Adjust running boards, centering on vehicle. Hand tight M8 hardware on running boards.
5) Follow the torque procedures, torque M8 hardware to 7 ft-lbs using a torque wrench.
6) Cleaning and maintaining your running boards is important, apply a light coat of a quality
carnauba wax at least 2X per year. Wash often with mild soap and make sure to remove all soap
Residue. Many car automatic carwashes use a strong soap, make sure to use enough water to
remove all residue.
7) Register your products at www.Romik.com/contact/productregistration
8) Warranty information at www.Romik.com/warranty