Ross LN2LTA200 User manual

8
LN2LTA200
Full motion
TV wall mount
Whilst every effort has been made to ensure that the provided screws are suitable for connecting the mount to the vast majority of
TV brands and models, Ross cannot be held responsible on the rare occasion that the supplied screws are not sufficient.
Contact us for more information at [email protected]
x1 x4
Easy installation:
Scan for installation video
For more information visit:
www.ross.uk
x4
6
G
x4
2
H
x4
1
H
x4
1
Gx4
2
Gx4
3
Gx4
4
G
M4 M4
x4
Cx2 D
M5 M5
x4
5
G
M6 M6
x4
8
G
x4
7
G
M8 M8
SET INCLUDES
x2
I
I
Slide the TV onto the bracket ensuring that the
TV is centered onto the mount.
x4
Ex1 F

1 2
6
7
Remove the covering clip off the bracket, and loosen
the secure bolt on the bracket.
When selecting the position of the TV mount ensure
that it is fixed onto a wooden joist or onto a solid
wall. Mark the wall where the fixing locations are
ensuring that the mount will be mounted on to a flat
surface and is level.
Using the provided self taping screws (B) type.
Holding the TV mount starting in the one corner,
screw the provided screws (B) into a wooden joist
fixing the opposite corners, until the mount is secure
onto the wall. Ensure all are tight and secure.
Clip the covers onto the
base of the unit.
Provided select the appropriate ones to hold the hooks (G) onto
the TV. Ensuring that the mounts are facing the the top end of your
TV screw the mount onto the TV ensuring not to over-tighten.
Using a screwdriver tighten the securing
bolts onto the mount and the bottom of
the cover.
Hold each side of the
TV with the hooks
facing away from you.
Slide the TV onto the
bracket ensuring that
the TV is centered
onto the mount.
4 5
A
1
H
1/2
G
7/8G
2
H
G3/4/5/6
1
H
E
G1
2
H
E
G3/5
E
G7
G
H
E
F
C
3
Using the provided self taping
screws (B) type. Holding the TV
mount starting in the one corner,
screw the provided screws (B) into
a wooden joist fixing the opposite
corners, until the mount is secure
onto the wall. Ensure all are tight
and secure.
When selecting the position of the TV
mount. Ensuring that the mount will
be mounted on to a flat surface and is
level. Mark the wall where the fixing
locations are. Drill the holes using a
10mm masonry bit. Using a hammer
knock the the wall plugs (C) provided
into the wall. Holding the TV mount
start in the one corner screw the
provided screws (B) into the wall
fixing the opposite corners until the
mount is secure onto the wall. Ensure
all are tight and secure.
Ensure that the mount is fixed to a
solid object and not into plasterboard
on its own.