Ruckus Wireless SmartZone 100 User manual

Get to Know the Physical Features of the Controller
The following sections identify the physical features of the controller that are relevant to the installation and mounting
instructions that this guide provides. Before you begin the installation process, Ruckus Networks strongly recommends that you
become familiar with these physical features.
Front Panel
The following gure shows the controller’s front panel with the bezel installed. For descriptions of the numbered parts, refer to
the table below.
FIGURE 3 The front panel of the SmartZone 100 (SKU P01-S124-WW10)
TABLE 3 Front panel parts
Number Description
1 10G Ethernet link LED (see LEDs on the Front Panel on page 15)
2 10G Ethernet speed LED (see LEDs on the Front Panel on page 15)
3 Two 10GBASE-X (SFP+) ports (SKU P01-S124-WW10 only)
4 F/D (factory default) button. Press this button for at least 10 seconds to reset the controller to factory default
settings.
5 Status LED (see LEDs on the Front Panel on page 15)
6 1000BASE-T link LED (see LEDs on the Front Panel on page 15)
7 1000BASE-T status LED (see LEDs on the Front Panel on page 15 )
8 Four 1000BASE-T (RJ-45) ports
9 Console (RJ-45 serial) port. Use the supplied console cable (or any rollover cable, also known as Cisco
™
serial RJ-45
cable) to connect this port to another device.
10 Two USB ports
11 Power LED (see LEDs on the Front Panel on page 15)
12 HDD LED (see LEDs on the Front Panel on page 15)
Before You Begin
Ruckus SmartZone 100 Getting Started Guide
14 Part Number: 800-71960-001 Rev A

TABLE 3 Front panel parts (continued)
Number Description
13 Reset button. Press for 5 seconds to restart the SZ 100.
LEDs on the Front Panel
The table below describes the behavior of the LEDs on the front panel.
TABLE 4 LED behavior
LED Description
10G Ethernet link LED Green: Operational
Flashing: TX/RX data
O: Not operational
10G Ethernet speed LED Blue: Operating at 10Gbps
Yellow/Orange: Operating 1Gbps
O: Not operational
Status Green: System operational/no fault
Red: System fault
Blinking red: Starting up or shutting down
Slow ashing red: System shut down
1000BASE-T link LED Green: Operational
Flashing green: TX/RX data
O: Not operational
1000BASE-T speed LED Green: 1000Mbps
Amber: 100Mbps
O: 10Mbps
Power On: Power available
O: No power
HDD On: Disk I/O (usually blinking)
O: No disk I/O
Rear Panel
The gure below shows the rear panel of the SmartZone 100. For descriptions of the numbered parts, refer to the table below.
Before You Begin
Ruckus SmartZone 100 Getting Started Guide
Part Number: 800-71960-001 Rev A 15