Rukket HAACK NET PRO User manual

HAACK NET PRO
ASSEMBLY INSTRUCTIONS
QUESTIONS? GIVE US A CALL! (1-855)-478-5538
V1
RukketSports
Our video instructions provide the best guidance for setting up your Haack Net Pro.
They can be viewed online at
Included Equipment:
Target
rukket
sports
Net
Carry bag Stakes

HAACK NET PRO
ASSEMBLY INSTRUCTIONS
QUESTIONS? GIVE US A CALL! (1-855)-478-5538
V1
Prior to use
- Please use adult supervision and follow the instructions when setting up
and using the net.
- Regular use or abuse will eventually strain the netting and may break it.
- Do not stand behind the net.
- This net is not intended for personal protection.
- Inspect the netting and frame for damage or wear.
- Make sure the frame and net are assembled correctly and on a at surface, at least ten (10) feet from structures and
vehicles.
- The user should be positioned directly in front of the net.
- Failure to follow these precautions could result in serious injury or damage to property.
1. Assemble the base.
Note: The buttons and holes for the rear pieces are all on the top of
the pipes, while the buttons and holes for the legs are on the sides
facing inward.
2. Lay out the net so that the four sleeves are on top of the net and
the net’s black border is near the base frame. The“Rukket Sports”
and “Rukket.com” logos will be facing outward when your net is
fully assembled.
3. Assemble the berglass poles. 4. Run both berglass poles through the sleeves.
Product Safety Warning
rukket
sports
rukket
sports
rukket
sports
rukket
sports

HAACK NET PRO
ASSEMBLY INSTRUCTIONS
QUESTIONS? GIVE US A CALL! (1-855)-478-5538
V1
7. Hang the net by looping the top-front red loops over the red
knobs on the fronts of the side arms. Loop the front-bottom loops
over the red hooks at the ends of the frame legs.
8. Attach the two upper-rear red loops to the black knobs on the
backs of the side arms.
9. Attach both ends of the target’s support rope to the backs of
the top side arms.
5. Lift one of the berglass poles upright and insert
the end closest to the base into the receiving post in
the base. Repeat on the other side.
6. Attach the upper side arms to the tops of the berglass poles
with the red knob pointing forward. You can bend the berglass
pole down to the left or right if
the top is too high to reach.
10. Run the buckle under the frame and clip. You can adjust the
target up and down and side-to-side for dierent clubs and
trajectories by sliding the red target along the white webbing and
sliding the white webbing along the base and
support rope, respectively.
rukket
sports