RVS MOBILEMULE RVS-6300 User manual
MOBILEMULE™ 4 CHANNEL MOBILE DVR WITH
GPS TRACKING AND LIVE VIDEO OPTIONS (HARD DRIVE)
RVS-6300
Instruction Manual
VEHICLE SAFETY -
IT'S ALL WE DO.
TM
Table of Contents
0
Before You Start
I
/
/
:
I
/
0
2
Product Specification
0
5
(Certain models)
(Certain models)
1 SDXC High speed card (up to 512GB)
6
Front/Back Panel
Front Panel Interface
Parameter
9
10
13
3.2 Back panel inteace
0
8
Back Panel Interface
Parameter
4
5
6
73G/4G
WiFi, GPS, 3G/4G
Coecting aviation cera
4 video
3 audio
�1+12v
�2G
Picture 3: Diagram of AV input cable
3
4
Table 3
Picture 4: Power input cable
0
+12v 1
GND 2 • 4video
3 audio
Picture 5: Installation wiring diagram
The power cable shown in picture four ends in a 6 pin white plug. This connects to the 6 pin white socket on
the back of the DVR. The red (+) and black (ground) connect to the vehicle directly. The yellow cable is
connected to ignition. The DVR will start when the vehicle is turned on and have a delayed shut out when the
vehicle is turned off.
1) Voltage must be between DC 6V-36V
2) Confirm cables are insulated after connected
3) Yellow cable is connected to ignition
4) Red and Black wires are connected to power/ground
3.3.3 Alarm 1/0
-
�
"
7-GND
8-ALM-OU
Picture 6:
A
larm
s
The device has an interface with 4 alarm inputs and 2 alarm outputs. These alarms can be
connects to a variet
y
of triggers. The principle diagram of brake detecon is as shown below.
When the brake pedal is pressed, the DVR is able to detect the high level or the low level.
@
24V
The alarm outputs have a maximum current capability of 200MA. If you want to drive a
device with higher current requirement, you must connect external relay. Shown below is the
alarm output wiring diagram.
RELAY
-------- + 24V
@
13
The SD card can be inserted from the front of the DVR. The SD card should be placed into SD
card port.
1. SD card installation instruction
Red wire is 12V positive, black is ground, yellow is video, green is audio.
Open the
DVR
to see both the
SIM
and
SD
card slots:
SIM SD
@
As shown in the figure, loosen the two screws on the le and right sides of the hard disk box
with a screwdriver.
R
emove the hard drive.
D
v
@
Rubber Cushion
Take the four screws out of the hard drive
Picture 12: Hard Drive disassembly figure 2
Remove the drive after taking out the screws.
Keyboard Input
System can use numbers, lower/uppercase English letters and Chinese
Characters.
DVR Operation Guide
Right click to open login interface:
Input Username/password, click OK to login to the menu.
Default Username is admin, with no password.
5.1 User Login
5.2 Video Preview
S
S
■
■
30
Table of contents
Other RVS DVR manuals
