Saeco Odea Giro Plus User manual

Setting Up the Machine
Odea Giro Plus Quick Start Guide
Please Read Before Operating Machine.
Giro Interface
Steam / Hot Water Wand
Adjustable Drip Tray
Sliding Wheel Base
On/Off Button
Coffee Bean Hopper
Parts of the Machine
WWaatteerrTTaannkk
··Remove water tank and fill with fresh water. (Figure 1)
··Replace water tank back onto machine.
BBeeaannHHooppppeerr
··Open bean hopper lid and fill with whole espresso beans*. (Figure 2)
··Replace bean hopper lid.
PPoowweerr
··Attach power cord to machine and plug into outlet. (Figure 3)
PPrriimmiinngg
··Place a cup under the steam/hot water wand.
··Turn the machine on by pressing the on/off button.
··The machine will automatically perform a rinsing cycle. A small
quantity of water will be dispensed.
··The cycle will be completed automatically.
YYoouurrmmaacchhiinneeiissnnoowwrreeaaddyyttoobbrreew
wffrreesshh,,ddeelliicciioouusseesspprreessssoo!!SSiimmppllyyppllaaccee
aaccuuppuunnddeerrtthheeddiissppeennssiinngghheeaadd,,aaddjjuusstttthheeccooffffeeeevvoolluummeed
diiaallaanndd
pprreesssstthheebbrreewwbbuuttttoonn((FFiigguurree44))ttooeexxppeerriieenncceetthheettaasstteeoofflluuxxuurryy..
Figure 2
Figure 1
Figure 3
Figure 4
Water Tank
Used Grounds Container
(Dregdrawer)
**
Please note, this machine has been inspected and tested. For this reason,
you may find a slight amount of coffee grounds in your machine.
Dispensing Head

Contact Us
Descaling
To keep your machine running in peak condition, we recommend descaling at least once every 3
months. For more detailed instructions on descaling your machine, please refer to the user manual.
1. Start with the machine turned off.
2. Fill the water tank with the descaling solution.(1 packet Saeco descaling solution to 4 cups water.)
3. Turn on the machine.
4. Run approximately 2 cups of solution through the steam/hot water wand.
5. Turn machine off and let the machine sit for 15 minutes.
6. Repeat steps 4 and 5 until the water tank is empty.
7. Rinse the water tank thoroughly and rise the circuits of the machine by running two tanks
of fresh water through the steam/hot water wand.
Giro Interface
For more detailed instructions on how to operate the espresso machine, please refer to the user manual.
If further assistance is needed, please contact SSaaeeccooCCuussttoommeerrSSeerrvviiccee::
call: 1-800-933-7876 • email: [email protected] • visit: www.saeco-usa.com
For parts and accessories, visit: www.saecooutlet.com
CCooffffeeeeBBuuttttoonn
Press this button to start brewing coffee. Press once for one cup, twice for
two cups. To stop brewing early, press the coffee button again.
HHoottWWaatteerrBBuuttttoonn
Press this button to select the hot water or steam function. When the light is
illuminated, the hot water function is selected. When the light is not illuminated,
the steam function is selected.
OOppttiiDDoosseeBBuuttttoonn
Press this button to control the amount of coffee that is ground for each
individual cup. It adjusts from 7-10.5 grams of ground beans per brewing
cycle.
UUsseeddGGrroouunnddssCCoonnttaaiinneerrLLiigghhtt
This light indicates that the used grounds container needs to be emptied.
This must be done while the machine is on.
RReeaaddyyLLiigghhtt
This light indicates that the machine warning up or ready to use. When the
light is on and flashing, the machines is warming up. When the light is on
steady, the machine is ready to use.
AAllaarrmmLLiigghhtt
This light indicates a machine warning. It may mean that the water tank or
brew group are not inserted correctly, or the machine is out of beans. Read
page 13 of the user manual for full descriptions of alarm light.
DDeessccaalliinnggLLiigghhtt
When this light is on and flashing, the machine needs to be descaled. Please
read the user manual for full instructions on descaling.