Safavieh Furniture Callia FOX4268 User manual

Model# FOX4268
Product Dimensions:L:16-1/2"WX16-1/2"DX31-1/2"H
PIECE QUANTITY
A1X
B2X
C1X
D1X
E2X
F1X
H1 10X
H2 1X
H3 4X
H4 1X
H5 4X
Allen bolt
M8X20mm
Allen key
Rubber cap
Bar-S
hex nut
Wrench
Bar-L
Top-S
Leg-S
DESCRIPTION
PICTURE
S:12-3/5"WX12-3/5"DX29-1/2"H
Top-L
Leg-L
CARE AND MAINTENANCE
Always use felt pads under allarticles to prevent discoloration or softening of the
lacquer. Plastic and rubber bases on items can discolor wood. Wipe up spills
immediately and avoid common hazards such as hot dishes,harsh solvents and
abrasives. Cleaning should be done with a soft lint free cotton cloth dampened with
water or furniture polish. On highly used surfaces we recommend applying a quality
paste wax which should be used on a regular basis to provide additional protection
from sratches and spills. How often you apply the wax depends on how much wear
the furniture receives.
NOTICE
* Please make sure that you have all parts indicated before you begin assembly of this
item
* This item should be assembled on a soft surface to prevent scratching the finish
during assembly
* This item may require periodic tightening
Part List and Hardware List

Step 1 Step 2 Step 3
Attach the legs(B) to the top (A),using hex nuts(H1) Attach the legs(B) to the top (A),using hex nuts(H1) Attach the bar (C) to the legs(B),using allen bolts(H3)
Tighten with wrench(H2) Tighten with wrench(H2) Tighten with Allen key(H4)
Step 4 Step 5 Step 6
Cover the holes with rubber caps(H5) Attach the legs(E) to the top (D),using hex nuts(H1) Attach the legs(E) to the top (D),using hex nuts(H1)
Tighten with wrench(H2) Tighten with wrench(H2)
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and
hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Tools Required for Assembly (included): Allen Key
1
2
3
4
5
6
7
8

Step 7 Step 8
Attach the bar (F) to the legs(E),using allen bolts(H3) Cover the holes with rubber caps(H5)
Tighten with Allen key(H4)
7
8