Safavieh Furniture Calliope CNS9701 User manual

NOTICE
* Please make sure that you have all parts indicated before you begin assembly of this item
* This item should be assembled on a soft surface to prevent scratching the finish during assembly
* This item may require periodic tightening
If you are having difficulty, our friendly Customer Care team is always here to help. Please email
[email protected]
*
PREPARATION
*Before beginning assembly of product, make sure all parts are present. Compare parts with part
contents list and hardware contents list.
*If any part is missing or damaged, do not attempt to assemble the product.
*Estimated Assembly Time: 10 minutes.
*Tools Required for Assembly (included): Allen Key
CARE AND MAINTENANCE
Always use felt pads under all articles to prevent discoloration or softening of the lacquer. Plastic and
rubber bases on items can discolor wood. Wipe up spills immediately and avoid common hazards such
as hot dishes, harsh solvents and abrasives. Cleaning should be done with a soft lint free cotton cloth
dampened with water or furniture polish. On highly used surfaces we recommend applying a quality
paste wax which should be used on a regular basis to provide additional protection from scratches and
spills. How often you apply the wax depends on how much wear the furniture receives.
much wear the furniture receives.
PIECE DESCRIPTION PICTURE QUANTITY
A Table top 1x
B Side legs 2x
C Mid leg 1x
D Connection board 2x
E Mid Connection board 1x
HW1 Flat washer 24x
HW2 Allen Bolt M8x30mm 24x
HW3 Allen Key M5 1x
Model# CNS9701
Product Dimensions:47.25''Wx15.8''Dx29.9''H
Page 1 of 2

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Tools Required for Assembly (included): Allen Key
If you are having difficulty, our friendly Customer Care team is always here to help. Please email [e-mail]
Attach connection board (D)(E) to the Leg (B)(C) using
the Allen Bolt (HW2) and Flat washer (HW1) as shown
above/
Turn Table top face down (A) and attach legs using the bolt and
washer for hole 2.
Step 1
Step 2
Page 2 of 2