Safavieh Furniture DTB1405 User manual

NOTICE
* Please make sure that you have all parts indicated and they are in good
hardware list below for guidance.
the finish during assembly.
* If you are having difficulty, our friendly Customer Care team is always
here to help. Please email [email protected]
PREPARATION
* Before beginning assembly of product, make sure all parts are present.
Compare parts with part contents list and hardware contents list.
product.
* Tools required for assembly (included) : Allen key
* Tools required for assembly (not included) : Philip screw driver
CARE AND MAINTENANCE
the lacquer. Wipe up spill immediately and avoid common hazards such as
Item Id : DTB1405
Product Dimensions : 47.24” W x 47.24” D x 29.52” H
Weight capacity - 165 LBS
Warning : Do not stand on table.
Warning : Do not over torque bolts.
20 minutes.
PIECE DESCRIPTION PICTURE QUANTITY
Part List and Hardware List
A1x
B 4x
C2x
D 1x
E 1x
HW 1 16x
HW 2 8x
HW 3 8x
HW 4 8x
HW 5 8x
HW 6 1x
Table Top
Leg
Cross Rail Up/Down
Pedestal
Pedestal Cap
Spring Washer 8mm
Csk Screw M4x2.0x30mm
Flat Washer 8mm
Nut 8mm
Jcbc Bolt M6x0.5x35mm
Castor Wheel With Lock
HW 7 1x
Spanner 12.8mm

PREPARATION
* Before beginning assembly of product, make sure all parts are present. Compare parts with part contents list and hardware contents list.
uct.
* Tools required for assembly (included) : Allen key
* Tools required for assembly (not included) : Philip Screw driver
* If you are having difficulty, our friendly Customer Care team is always here to help. Please email [email protected]
Step 1 : Assemble the leg and to the pedestal. Step 2 : Place the cross rail then screw it to the leg with the bolts.
** Remark : Do not fullly tighten all the
nuts before completing step 2.
** Remark : Fully tighten all the nuts in
step 1 after assembled the cross rail.

PREPARATION
* Before beginning assembly of product, make sure all parts are present. Compare parts with part contents list and hardware contents list.
uct.
* Tools required for assembly (included) : Allen key
* Tools required for assembly (not included) : Philip Screw driver
* If you are having difficulty, our friendly Customer Care team is always here to help. Please email [email protected]
Step 3 : Place the table top upside down, then screw the leg frame. Make
sure to place on the smooth and clear surface to avoid the surface
scratch.
Step 4 : Place the pedestal cap on the pedestal.
1. There is no pre-drilled hole underneath
2. Placing Cross Bar onto the pre-drawn
crossing mark then insert the Screw “A”
into the hole found on the cross bar.
3. Screwing all Screws “A” into the
Table Top by ensuring the cross bar is
aligned to the crossing mark.
** Please ignore this hole. This hole is not
meant for assembly.