Safavieh Furniture Tyler HUD4069 User manual

NOTICE
*
. .
* .
* .
* , .
@ .
Please make sure that you have all parts indicated and they are in good condition before you
begin assembly of this item Refer to part list and hardware list below for guidance
This item should be assembled on a soft surface to prevent scratching the finish during assembly
This item may require periodic tightening
If you are having difficulty our friendly Customer Care team is always here to help Please
email customersupport safavieh com
PREPARATION
* , .
.
* , .
* : .
* ( ):
Before beginning assembly of product make sure all parts are present Compare parts with
part contents list and hardware contents list
If any part is missing or damaged do not attempt to assemble the product
Estimated Assembly Time 10 minutes
Tolls Required for Assembly included Allen Key
CARE AND MAINTENCE
*
*
*
Spot clean using a mild water-free solvent.
Only a professional cleaner should undertake a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
Item ID HUD4069
Product Dimensions:46.9" W x 20" D x 18.1" H
:
Part List and Hardware List
PIECE DESCRIPTION PICTURE QUANTITY
A
B
Seat Body
Legs
Allen bolt M8 x 1.25 x 55 mm:
Spring Washer M8:
Flat Washer :M8x22mm
Allen Key
Weight Capacity: 275 lbs
WARNING: DO NOT STAND ON CHAIR
WARNING: DO NOT OVER TORQUE BOLTS/SCREWS
WARNING
1X
8X
8X
1X
8X
4X
HW1
HW3
HW4
HW2

PREPARATION
* , .
.
* , .
* : .
* ( ):
* , . @ .
Before beginning assembly of product make sure all parts are present Compare parts with
part contents list and hardware contents list
If any part is missing or damaged do not attempt to assemble the product
Estimated Assembly Time 10 minutes
Tolls Required for Assembly included Allen Key
If you are having difficulty our friendly Customer Care team is always here to help Please email customersupport safavieh com
HW1 HW2 HW3
HW1 HW2 HW3
HW4
STEP 1 OPEN THE ZIPPER ON THE UNDERSIDE OF
THE SEAT AND TAKE OUT LEGS AND HARDWARE.
:STEP 2 PUT THE WASHERS ON THE BOLT IN
THE ORDER SHOWN IN THE PICTURE.
:STEP 3:ASSEMBLY THE FRONT LEGS
BUT DON'T TIGHTEN COMPLETELY.
AND SCREW IN THE
BOLTS.
STEP4 PUT THE CHAIR UPRIGHT AND MAKE SURE
ALL LEGS ARE LEVEL, THEN FIRMLY TIGHTEN BOLTS
WITH ALLEN KEY WHILE THE CHAIR IS UPRIGHT
AS PICTURED ABOVE.
:STEP5 CLOSE THE ZIPPER ON THE UNDERSIDE OF
THE SEAT, THIS ITEM MAY REQUIRE PERIODIC TIGHTENING
:
.