Safavieh MCR4045 User manual

PIECE QUANTITY
A1X
B2X
H1 4X
H2 12X
H3
4X
H4 4X
Step 1 Step 2
Remove the legs (B) from the back of the headboard (A) by
unscrewing the 2 big cross bolts (H3) and 2 washers (H2). The
bolts and washers need to be re-used to attach the legs in the
correct position in Step 2.
ASSEMBLY INSTRUCTIONS APPLICABLE FOR ALL
SAFAVIEH HEADBOARDS.
THE DESIGN OF THE HEADBOARD IN THE DRAWINGS
MAY VARY FROM YOUR ACTUAL HEADBOARD, BUT
ASSEMBLY IS THE SAME ON ALL MODELS AND
SIZES.
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and
hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Attach the two legs (B) to the headboard (A) using 4 big
cross bolts (H3) and 4 washers (H2).
The vertical slots at the lower part of the leg must be
facing the outside of the bed.
Small bolt M6 x 25mm
The hardware that is needed to connect the headboard to the bed frame is included.
Please note that our headboard legs are compatible to most standard bedframes. Our
headboards DO NOT include a mounting bracket*.
Example of Mounting
Bracket*
PREPARATION
Nut
Washer
Big bolt M8 x 30mm
DESCRIPTION
PICTURE
Headboard
Metal Leg
CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should
undertake a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
NOTICE
* Please make sure that you have all parts indicated before you begin assembly of this
item
* This item should be assembled on a soft surface to prevent scratching the finish
during assembly
* This item may require periodic tightening
Parts List and Hardware List
H1
H2
H2
H4
B
B
B
A
B
H3
H2
H1
H2
H2
H4
Use the left slot to attach
the metal leg to the left
side of the metal frame
on the left side. Use the
right slot on the right
side.
A
B
Unscrew 2 bolts and 2 washers
B

Step 3 Step 4
The hardware needed to connect the headboard to the bed
frame are 4 small bolts (H4), 8 washers (H2), and 4 nuts (H1)
Attach the legs of the headboard (B) to the bed frame or
mounting bracket by fixing them together through the 2
holes in the bed frame and the vertical slot in the leg using
4 small bolts (H4), 8 washers (H2) and 4 nuts (H1)
H1
H2
H2
H4
B