Safavieh Arlyss ACH4010 User manual

CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should undertake a
complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
Model# ACH4010
Product Dimensions:30" W x 33" D x 36" H
NOTICE Weight Capacity: 275 lbs
* Please make sure that you have all parts indicated before you begin assembly of this
item
* This item should be assembled on a soft surface to prevent scratching the finish during
assembly
* This item may require periodic tightening
Part List and Hardware List
PIECE DESCRIPTION PICTURE QUANTITY
A Seat Body 1X
B Front Leg 2X
C Rear Leg 2X
HW1 Allen bolt ( 8 x 1.25 x 55 mm ) 8X WARNING: DO NOT STAND ON CHAIR
HW2 Spring washer (8mm ) 8X WARNING: DO NOT OVER TORQUE BOLTS/SCREWS
HW3 Flat washer (8mm) 8X
HW4 Allen key 1X
The legs and hardware are located in the small box underneath
the chair in the zipper compartment.

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Tools Required for Assembly (included): Allen Key
STEP1 OPEN THE ZIPPER ON THE UNDERSIDE OF THE SEAT
AND TAKE OUT LEGS AND HARDWARE.
STEP2 PUT THE WASHERS ON THE BOLT IN THE ORDER
SHOWN IN THE PICTURE.
STEP3 INSERT THE FRONT LEGS AND SCREW IN THE BOLTS
. BUT DON'T TIGHTEN COMPLETELY.
STEP4 INSERT THE REAR LEGS AND SCREW IN THE BOLTS
BUT DON'T TIGHTEN COMPLETELY.
STEP5 PUT THE CHAIR UPRIGHT AND MAKE SURE ALL
LEGS ARE LEVEL, THEN FIRMLY TIGHTEN BOLTS WITH
ALLEN KEY WHILE THE CHAIR IS UPRIGHT AS PICTURED
ABOVE.
STEP6 ZIP THE COVEVR ON BOTTOM OF SEAT.THIS ITEM
MAY REQUIRE PERIODIC TIGHTENING.
The legs and hardware are located in the small box underneath
the chair in the zipper compartment.