Safavieh KNT4039A User manual

CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should undertake
a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
NOTICE
*Please make sure that you have all parts indicated before you begin assembly of this item.
*This item should be assembled on a soft surface to prevent scratching the finish during assembly.
*This item may require periodic tightening.
Parts List and Hardware List Model# KNT4039A
Product Dimensions: 86.5” W*86” D*63” H
PIECE DESCRIPTION PICTURE QUANTITY
A Headboard 1x
B Side rail 2x
C Footboard 1x
D Cross Support Slat 5x
E
Center Support
Foot
5x
1 Screws 10x
2
Allen Head Bolt
（0.8cm Dia)
Attached on the
Bed
3 Allen Key 1x
TOOLS NEEDED
Phillips Screwdriver （not included)
*** The hardwares are packed with the headbard

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assemble Time: 5 minutes.
12
Step 1 Step 2
1. Place the Headboard (A) flat on the floor covered with with a protective 1. Locate the Center support foot(E) onto the Cross Support Slat (D) as shown
material to prevent damage. in the Diagram II
2. Stand the Headboard (A) upright and hook Side Rails (B) into Headboard 2. Place the Cross Support Slat (D) on the inside of the Headboard (A) and
(A) as shown in the Diagram I. Footboard (B).
Tighten the Allen Bolts(2),with Allen Key(3) Screw the ends of the slats to the cleats using Screw (1), as shown in
3. Repeat the procedure with the Footboard (C). Diagram III.

1. Locate the Center support foot(E) onto the Cross Support Slat (D) as shown