Safavieh Olyvar ACH4000 User manual

CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should
undertake a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or
staining.
Model# ACH4000
Product Dimensions::25" W x 31.5" D x 35.5" H
NOTICE Weight Capacity: 275 lbs
* Please make sure that you have all parts indicated before you begin assembly of
this item
* This item should be assembled on a soft surface to prevent scratching the finish
during assembly
* This item may require periodic tightening
Part List and Hardware List
PIECE DESCRIPTION PICTURE QUANTITY
A Seat Body 1X
B Left Chair Arm 1X
C Right Chair Arm 1X
HW1 Allen bolt (8 x 1.25 x 55mm) 6X
HW2 Spring washer (8mm) 4X WARNING: DO NOT STAND ON CHAIR
HW3 Flat washer (8mm x 22mm) 4X WARNING: DO NOT OVER TORQUE BOLTS/SCREWS
HW4 Flat washer (8mm x 13mm) 2X
HW5 Allen key 1X
The legs and hardware are located in the small box under the seat
body.

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Tools Required for Assembly (included): Allen Key
STEP1 TAKE OUT LEGS AND HARDWARE FROM THE BOX
UNDER THE SEATBODY.
STEP2 PUT THE WASHERS ON THE BOLT IN THE ORDER SHOWN
IN THE PICTURE.
STEP3 PUT LEFT CHAIR ARM AND RIGHT CHAIR ARM ONTO
SEAT BODY .SCREW IN THE BOLTS . BUT DON'T TIGHTEN
COMPLETELY.
STEP4 SCREW IN THE BOLTS BETWEEN TWO ARM AND
TIGHTEN IT.
STEP5 PUT THE CHAIR UPRIGHT AND MAKE SURE ALL LEGS ARE
LEVEL, THEN FIRMLY TIGHTEN BOLTS WITH ALLEN KEY WHILE
THE CHAIR IS UPRIGHT AS PICTURED ABOVE.
STEP6 ZIP THE COVEVR ON BOTTOM OF SEAT.THIS ITEM MAY
REQUIRE PERIODIC TIGHTENING.
The legs and hardware are located in the small box under the seat
body.