Safavieh PAT6749 User manual

CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should
undertake a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
NOTICE
* Please make sure all parts are included before you begin assembly of this item.
* This item should be assembled on a soft surface to prevent scratching the finish during
assembly
* This item may require periodic tightening
Parts List and Hardware List
O U T D O O R
Item# PAT6749
Product dimension:
ASSEMBLY INSTRUCTIONS FOR SAFAVIEH
LARDNER LIVING
THE DESIGN OF LARDNER LIVING IN THE DRAWINGS MAY VARY
FROM ACTUAL, BUT ASSEMBLY CAN BE APPLIED
FOR THIS ITEM
Weight Capacity: 550 lbs per bench & 88 lbs per table
WARNING: DO NOT STAND ON BENCH & TABLE
WARNING: DO NOT OVER TORQUE BOLTS/SCREWS
ID Q.tysPICTURE & DESCRIPTION ID Q.tysPICTURE & DESCRIPTION
A I
M1
M2
M3
M4
M5
M6
M7
B
C
D
E
F
G
H
Table top Cushion seat
Screw
Ø 7x120 mm
Screw
Ø 7x60 mm
Nuts
Ø 6x13 mm
Bolts
Ø 6x30 mm
Screw
Ø 4x15 mm
wooden dowel
Ø 10x30 mm
Table legs
Cross bar
of table
Left bench leg
Right bench leg
Backrest
Seat
Pillow
1X 4X
12X
10X
8X
8X
4X
8X
2X
1X
2X
2X
2X
2X
2X
4X Allen key
Table : 23,62”W x 23,62”D x 21,65”H
Bench: 52,76”W x 24,6”D x 29,53”H

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Tools Required for Assembly: Allen Key (included), screw Driver (not included)
Step 1: attach table leg frame (B) to table top (A) & low cross bar (C),
using screws (M1 & M2). Fully tighten using Allen Key (M7)
Step 1: Fix the seat bench (F) to Backrest (G) using Bolts (M4) & Nuts
(M3). Fully tighten using Allen Key (M7)
Step 2: insert Wooden dowel (M6) into the hole in bench seat (G) then
attach the right leg frame (D) to the assembled frame. Tighten using
Allen Key (M7). Repeat for the left leg frame (E).Do not fully tighten
Screw until all are installed.
M1
M1
M1
M1
A
M2
M2
M3 M3 M3 M3
M4
M6
M4
M4
M4
M1
M1
M2
M2
F
G
F
D
C
B
B
E
G
M6

Step 3: Secure backrest to leg frame using screw (M5) tighten using
screw driver (not included)
Step 4: Place all cushions as shown
M5
HH
I
I
X2
Option 1 in shown Option 2 in shown