Safe & sound SA8092 User manual

VOICE MODE
PROBE
LCD
VOICE
MODE
MEM
SCAN
MODE
ºC / ºF
Safe & Sound Infrared Talking Thermometer
Instructions
Carefully read all the instructions and warnings
on this leaflet before use.
This item is not waterproof, do not immerse
in water.
Store out of reach of children, in a cool dry
place away from dust and avoid sunlight and
direct heat sources.
Always consult your doctor concerning raised
temperatures and any other worrying
symptoms. It may be a good idea to establish
and record your usual temperature regularly
when not ill.
Whilst individuals may vary, normal
temperature is considered to be 37°C.
However, body temperature can vary from
36°C, up to the normal level.
A mild rise in temperature would be to about
37.4°C and you should consult your doctor if
your temperature remains at this for more than
24 hours or if your temperature rises to 38°C
and above.
Directions
Before measuring temperature, the thermometer
should be stabilised at the operating ambient
temperature for at least 30 minutes. The LCD will
display Er 1 when the ambient temperature is out
of range and cannot display temperatures.
Press the SCAN button to turn on the
thermometer. When the LCD displays 0.0°C or
---°C the thermometer is ready to use.
Setting the mode: After turning on the
thermometer press the MODE button to change
the measurement mode. (Face icon) body
temperature mode (cup icon) surface and liquid
temperature mode (house icon) room
temperature mode.
Taking temperature: The probe shall be aimed
at the forehead or other surface, from a distance
of 1-3cm, press the SCAN button and then
release it. When the measurement is complete,
the thermometer will report the measured
temperature, at the same time you can move the
thermometer away. The display will show the
measured temperature.
When in body temperature mode if the illuminated
display is orange, it indicates that you may have a low
fever. And if the display is red, it indicates that you
may have a high fever.
The display will show L if temperature is lower than
the measurement range and Hi if above the
temperature range.
If measuring temperature again, repeat as above. The
time between each reading should not be less than 1
minute.
Unit switch: Press the °C/°F button to switch between
Celsius and Fahrenheit.
Memory search: Press the MEM to display the last
temperatures taken. The thermometer will store the
last 32 temperatures taken.
Voice option: Press the VOICE MODE to turn the
talking feature on and off.
The thermometer will shut off automatically after 1
minute of inactivity. Alternatively if the MODE button is
held for about 4 seconds the thermometer will turn off.
Important: The area temperature differs from the
internal body temperature. Please ensure body mode
is selected for an internal temperature reading and
surface mode is selected for an external area reading.

Made In: PRC. Produced for: Paul Murray Plc, Wide Lane, Southampton, SO18 2FA, UK. www.murrayshealthandbeauty.com
PLEASE RETAIN THE INFORMATION ON THIS PACK FOR FUTURE REFERENCE
Cleaning & Storage
Store the thermometer in the bag provided in a
cool dry place away from dust and avoid
sunlight and direct heat sources.
To clean; use an alcohol swab or cotton swab
with alcohol (70% Isopropyl), ensure no liquid
enters the interior of the item. Never use
abrasive cleaning agents or thinners to clean.
Never immerse the thermometer into water or
other cleaning liquids. Take care not to scratch
the surface of the probe lens or display.
Replacing the Batteries
The LCD will indicate the battery symbol when
the batteries require replacement. Replace both
the batteries to ensure the thermometer works
accurately.
Unclip the battery cover and remove old
batteries. The replacement batteries should be
of the same type (1.5V AAA) and must be
installed according to the correct polarity.
Replace the battery cover.
Remove batteries if the unit is not being used
for a long period of time to prevent them from
leaking. Do not throw away used batteries in
household waste. Dispose of batteries at your
local waste disposal centre in the appropriate
battery dispose site.
WARNINGS
Thoroughly inspect all parts before the first use
and before each subsequent use to ensure that
there are no defects, signs of wear or foreign
particles. Discard immediately if signs of wear,
damage or defect are noted.
Keep away from children when not in use as
small parts could present a choking hazard.
Use only under adult supervision.
Do not use near strong electromagnetic fields, i.e.
keep away from radio systems or mobile phones.
Only use this item in accordance with supplied
instructions and in accordance with any advice
from your doctor or other healthcare professional.
Explanation of symbols:
These symbols mean that you must not throw away the product
and batteries in household waste. Dispose of the product and
batteries at your local waste disposal centre for correct
treatment and recycling.
REVISION 2 April 2018
Type BF equipment.
The product is in
compliance with
93/42/EEC 0120.
This indicates the lot number –
note that the first four digits of
the lot number is also the year
and month of manufacture.
WEE / AF0043SY / PRO
Specification
Temperature Measurement Range:
Body Mode 32.0°C – 42.9°C (89.6°F – 109.2°F)
Accuracy ± 0.3°C (32.0°C – 42.9°C)
± 0.5°F (89.6°F – 109.2°F)
Surface Mode 0°C – 60.0°C (32.0°F – 140°F)
Accuracy ± 1°C (0°C – 60°C)
± 2°F (32°F – 140°F)
Room Mode 0°C – 40.0°C (32.0°F – 104°F)
Accuracy ± 0.5°C (0°C – 40°C)
± 0.9°F (32°F – 104°F)
Operating ambient:
Body and Surface mode
Temperature: 10°C - 40°C (50°F – 104°F)
Humidity: ≤85% RH
Room mode
Temperature: 0°C - 40°C (32°F – 104°F)
Humidity: ≤85% RH
Storage and transport condition
Temperature: -20°C - 55°C (-4°F – 131°F)
Humidity: ≤93% RH
Display resolution temperature range: 0.1°C (0.1°F)
Display: Tricolour colour coded display; green: normal
temperature, orange: low fever, red: high fever.
Temperature readings in °C and °F
Display memory: Last 32 readings.
Power consumption: ≤300mW
Battery life: Over 4000 times with 2 x AAA batteries
Dimension: 158mm x 45mm x 35mm
Net weight: 65g
Calibration: If used privately, no calibration is required.
For professional use, it is recommended to check
calibration once a year.