Saflok GARDLOK ES300 User manual

HEIGHTS KEY LOCK & SAFE
920 San Mateo NE Albuquerque, NM 87108
Contact us for more information Home Page
GARDLOK ES300 by Winfield lock / Saflok
The GardLok is an electronic push button lock designed to
retrofit existing Adams Rite locks installed on narrow stile
aluminum frame doors. Ten different access
combinations can be programmed for lock access. User's
access can be easily change or blocked.
Low Battery Warning
THERE IS NO "POWER OVER-RIDE" OR "KEY OVER-RIDE" FOR THIS LOCK. IT IS VERY
IMPORTANT TO KNOW THE LOW BATTERY WARNING SIGNS!
Stage 1 - Codes will need to be entered twice to trigger lock followed by eight
(8) rapid beeps. This will only occur for 20 openings.
Final Stage - Codes will need to be entered three (3) times before the lock will
open. If the battery is not changed the lock will eventually stop working
To enter a New Master Code
The Master Code is always stored in key '1' of the lock. All other nine combinations
are stored in keys 2 to 0.
1. Press & hold the '0' key until the lock beeps twice
2. Enter existing Master Code (factory default is 111111) followed by the '1' button -
the lock will beep twice.
3. Enter a new 6-digit Master - the lock will beep twice.
4. Re-enter the new Master code to confirm - a long beep will sound indicating a
successful change.

To Add or Change a User Code
Each User Code is stored in one of the remaining nine keys (2 through 0).
1. Press & hold the '0' key until the lock beeps twice.
2. Enter Master Code - the lock will beep twice.
3. Press the key to assigned to this user (2 through 0) - the lock will beep twice.
4. Enter 6-digit User Code - the lock will beep twice.
5. Re-enter 6-digit User Code - a long beep will sound indicating a successful
add/change.
To Enable or Disable a User Code
1. Press & hold the '0' key until the lock beeps twice.
2. Enter Master Code - the lock will beep twice.
3. Press the key to assigned to the user you want to disable (2 through 0) - the lock
will beep twice.
4. Choose one of the following
a. To Disable a User Code - Press and hold the '2' button until the lock beeps
twice indicating the Users Code is disabled.
b. To re-enable a User Code - Press and hold the '4' button until the lock beeps
twice indicating the Users Code is enabled.