SainSmart Genmitsu User manual

19
Part 2: Mechanical installation
NAME QTY.
Step 10: Aluminum Workbench Installation
NO.
Operation
Steps
Prepare
materials
BEFORE
AFTER
CODE
Tools
Check
Remind
Aluminum Workbench
Base (from Step 9)
1
1
MX3-3
Allen wrench ( 5 mm) & Open end wrenchs
Turn over the Base in the side of the Aluminum
workbench, move the base and make sure the nuts insert
into the three channels of the workbench.
Move the workbench in the middle of the base, keep the
Workbench from the left and right side for 10mm, put two
open end wrenchs on the Phenolic resin plate-F,then slow
This way for the workbench will be completely square with
the spindle later.
rotate the screw until touch the wrenchs, now it sure the
same gap and Parallel to plate-F, tighten all the M6 Bolts.
2
1
1
2
MX3-31
10mm 10mm