Salton JK1282 User manual

Instruction Booklet
Model JK1282
Salton_JK1282_BookletCover_E.indd 1Salton_JK1282_BookletCover_E.indd 1 13-01-18 4:08 PM13-01-18 4:08 PM

IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always
be followed including the following:
1. Read all instructions.
2. DO NOT touch hot surfaces. Use handles or knobs.
3. To protect against electrical hazards, DO NOT immerse cord, plugs,
or the appliance in water or other liquid.
4. Close supervision is necessary when any appliance is used by or near children.
5. Unplug from outlet when not in use and before cleaning. Allow to cool
before putting on or taking off parts, and before cleaning the appliance.
6. DO NOT operate any appliance with a damaged cord or plug or after
the appliance malfunctions, or has been damaged in any manner.
Return appliance to Salton for examination, repair or adjustment.
See Warranty section.
7. The use of accessories or attachments not recommended by Salton may
result in fire, electric shock or personal injury.
8. DO NOT use outdoors.
9. DO NOT let cord hang over edge of table or counter, or touch hot surfaces.
10. DO NOT place on or near a hot gas or electric burner, or in a heated oven.
11. Always attach plug to appliance first, then plug cord into the wall outlet. To
disconnect, turn any control to ‘OFF’, then remove plug from wall outlet.
12. DO NOT use appliance for other than intended use.
13. DO NOT leave unit unattended while in use.
14. Extreme caution must be used when moving an appliance containing
hot liquids.
2
HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
Booklet_JK1282_Eng_Silhouette 5/13/11 9:57 AM Page 2

3
GROUNDED PLUG
To reduce the risk of electric shock this appliance has a grounded plug (2 blades
and 1 pin). If the plug does not fit fully into the electrical outlet contact a qualified
electrician. Do not modify the plug in any way or use an adaptor.
BEFORE FIRST USE
1. Read all instructions carefully and keep them for future reference.
2. Remove all packaging.
3. Water boiled for the first time should be discarded.
INSTRUCTION FOR USE
1. The Filter has been installed in the Kettle before shipping. If it has been
removed, install the Filter before using the Kettle. See the Care and
Cleaning section.
- DO NOT use the Kettle without the Filter in position as water may spill
out when boiling.
- DO NOT REMOVE THE FILTER WHEN THE KETTLE IS HOT.
2. Fill Kettle between the minimum and maximum levels shown on the Water
Level Window.
NOTE:
DO NOT attempt to fill while the Kettle is on the Power Base.
DO NOT use for other than boiling water. Other liquids will contaminate
the interior of the Kettle.
DO NOT fill past the MAX level indicated on the Water Level Window.
Overfilling may cause water to spill out when boiling.
3. Place Kettle on Base making sure it is correctly engaged on its Base.
4. Plug Power Base cord into a 120V AC wall outlet. NOTE: Never plug Power
Base with empty Kettle into the electrical outlet.
5. Depress the On/Off Switch to the ‘On’ position. The Indicator Light will
illuminate to indicate that the Kettle is in the boil cycle. Once the water
has boiled, the On/Off Switch will automatically switch to the ‘Off’ position
and the Indicator Light will go out.
Booklet_JK1282_Eng_Silhouette 5/13/11 9:57 AM Page 3

6. If you want to use the Kettle again, allow the thermal safety switch to cool
down for 15 – 20 seconds then depress the On/Off Switch to the On
position. If the On/Off Switch does not remain in the ‘On’ position,
the Water is hot enough to use without reheating.
7. Unplug cord from wall outlet before lifting Kettle from Power Base.
Grip the Kettle by the Handle only, as the surface and lid will be hot.
8. Return the Kettle to the Power Base or place on a heat resistant surface
after use.
9. If the Kettle is accidently switched on when empty, the thermostat will
automatically cycle switching the Kettle off and allowing it to cool down
then switching it back on. If this situation occurs, unplug the Power Base
and let the Kettle cool before refilling.
10. It is recommended that the power cord be disconnected from the wall
outlet when not in use. DO NOT attempt to connect any other appliance
to the Power Base or tamper with the connector in any way.
CARE AND CLEANING
1. Unplug power cord from wall outlet. Empty out remaining water and
allow Kettle to cool before cleaning.
2. If necessary, remove and clean the Aquascreen Filter®by rinsing under running
water. The Filter can be removed by grasping firmly between your thumb
and forefinger and gently twisting off starting at either the right or left edge.
3. Under normal use, a deposit of scale may form on the inside of the Kettle
and cause some discolouration. Scale, which has accumulated inside
the Kettle, can be removed by boiling equal parts of white vinegar and
water (500 ml / 2 cups of each is recommended). Once the water has
boiled, allow mixture to stand several hours or overnight. Empty out
mixture and fill Kettle to the MAX level with fresh water. Bring water
to a boil and discard. For heavy scale build-up, repeat this process.
NOTE: This build-up can be delayed by pouring out old water and refilling
before each use.
4. DO NOT USE ABRASIVE CLEANERS
5. DO NOT ALLOW WATER TO ENTER THE POWER BASE
6. DO NOT IMMERSE KETTLE OR POWER BASE IN WATER OR OTHER LIQUID.
4
Booklet_JK1282_Eng_Silhouette 5/13/11 9:57 AM Page 4

5
A short supply cord is provided to reduce the hazards of becoming entangled
in or tripping over a long cord. Extension cords may be used if care is
exercised in their use. If an extension cord is used, the marked electrical rating
of the detachable power-supply cord or extension cord should be at least as
great as the electrical rating of the appliance. If the appliance is of the
grounded type, the extension cord should be a grounded 3-wire cord. The
extension cord should be arranged so that it will not drape over the counter
top or table top, where it can be pulled on by children or tripped over.
LIMITED WARRANTY
Salton Canada warrants that this appliance shall be free from defects in material and
workmanship for a period of one year from the date of purchase. During this
‘in-warranty’ period, defective products will be repaired or replaced at the discretion
of the retailer and/or Salton Canada. This warranty covers normal domestic usage
and does not cover damage which occurs in shipment or failure which results from
alteration, accident, misuse, abuse, glass breakage, neglect, commercial use or
improper maintenance.
A defective product should be returned to the original place of purchase within the
retailer’s stipulated return/exchange period*. If you are unable to have a defective
product replaced under warranty by the retailer, please check our website at
“www.salton.com” for the service centre nearest you. You may also contact us for
assistance by mail, e-mail, fax or telephone as listed below.
To ensure prompt ‘in-warranty’ service securely package and return the product to us
prepaid. Be sure to include the original proof of purchase and a description of the
defect along with your address and postal code.
For repairs not covered by the warranty, please contact us for assistance.
SALTON CANADA
Customer Service Department
81A Brunswick,
Dollard-des-Ormeaux,
Quebec, Canada H9B 2J5
website: www.salton.com
E-mail: [email protected]
Fax: [phone]
Tel: [phone] Ext. 226
* Return/exchange policies at each retailer vary and may differ from the SALTON Canada 1 year limited
warranty period.
Booklet_JK1282_Eng_Silhouette 5/13/11 9:57 AM Page 5