Salus Smart Plug SP600 User manual

Smart Plug
Model: SP600
Installation Manual
Introduction
Smart Plugs go directly into an open outlet (like an extension
of the outlet) giving a user connected control over the device
plugged into the equipment. Salus offers standardized Smart
Plugs for EU, UK and U.S. This product must be used with the
UniversalGateway(UG600/UGE600)andtheSalus Smart Home
App. Go to www.salus-smarthome.com for the PDF version
of the manual.
Product Compliance
This product complies with the essential requirements and other
relevant provisions of Directive 2014/30/EU, 2014/35/EU, 2014/53/EU
and 2011/65/EU. The full text of the EU Declaration of Conformity is
available at the following internet address: www.saluslegal.com.
Safety Information
Use in accordance with the regulations.
Designed to be used exclusively indoor.
Keep your device completely dry.
Disconnect your device before cleaning it with a dry towel.
SALUS Controls plc
SALUS House
Dodworth Business Park South,
Whinby Road,
Dodworth, Barnsley S75 3SP, UK.
Sales: T: [phone]
E: [email protected]
Technical: T: [phone]
E: [email protected]
www.salus-controls.com
SALUS Controls is a member of the Computime Group
Maintaining a policy of continuous product development SALUS Controls plc
reserve the right to change specification, design and materials of products
listed in this brochure without prior notice.
Issue Date: May 2016
V0011
For PDF Installation guide please go to
www.salus-manuals.com
Ensure your socket switch
is permanently on.
V = 230AC 50HZ
A = 13 Amp max.
After initialisation the LED will start
flashing continuously.
1
3

3
The LED will
go off.
Exit gatewayOperating the Plug
If you want to exit the gateway, follow the
steps below.
Press the button
for 10 seconds.
Will flash red
5 times.
Via the App Via the Plug
ON
Via the App Via the Plug
OFF
- Follow the on screen instructions.
- Once connected, the Smart Plug LED will stop flashing.
4 5 62
3