Samsung AW08NK Series User manual

B98-26970A(7)
USER'S MANUAL
A
AW08NK Series
W08NH Series
Window-type Room Air Conditioner (Cooling)

E-3
PREPARING YOUR AIR CONDITIONER
Safety Precautions ......................................................................................... 2
Description of Each Component .................................................................... 4
Remote Control - Buttons .............................................................................. 5
Getting Started ............................................................................................... 6
Inserting the Remote Control Batteries .......................................................... 7
OPERATING YOUR AIR CONDITIONER
Cooling Your Room ........................................................................................ 8
Airing Your Room ........................................................................................... 9
Removing Excess Humidity ............................................................................ 10
Adjusting the Air Flow Direction Horizontally .................................................. 11
Adjusting the Air Flow Direction Vertically ...................................................... 11
PROGRAMMING YOUR AIR CONDITIONER
Setting the On Timer ...................................................................................... 12
Setting the Off Timer ...................................................................................... 13
Selecting Good Sleep mode .......................................................................... 14
Selecting Energy Saving mode ...................................................................... 15
RECOMMENDATIONS FOR USE
Temperature and Humidity Ranges ................................................................ 16
Cleaning Your Air Conditioner ........................................................................ 17
Solving Common Problems ............................................................................ 18
Contents
Technical Specifications ................................................................................. 18
......................................................................................................... 19

Good Sleep setting button
Timer setting button
Fan speed adjustment button
On/Off button
Air outlet
Air inlet (Outside)
Air filter (Inside)
Temperature adjustment
buttons
Temperature/Timer
settings
Remote control sensor
Energy Saver button
Mode selection button
(Cool,Dry,Fan)
Air inlet(Inside)
.

E-5
Remote Control - Buttons
Timer setting button
Selecting Good Sleep
button
Operating mode
selection button
Energy Saver button
Temperature adjustment
button
On/Off button
Fan speed adjustment
button

(
*HWWLQJ6WDUWHG
&*-,/1+1 +,1"
-/"00-20%
6KQ D=RA FQOP LQN?D=OA@ = 0=IOQJC SEJ@KSPULA/KKIEN KJ@EPEKJAN SDE?D ODKQH@ >A EJOP=HHA@
>UBKHHKSEJC UKQN EJOP=HH=PEKJ I=JQ=H
6KQN ,SJANO &JOPNQ?PEKJO ?KJP=EJ R=HQ=>HA EJBKNI=PEKJ KJ QOEJC UKQN =EN ?KJ@EPEKJAN
-HA=OA P=GA PDA PEIA PK NA=@ PDAI =O PDAU SEHH DAHL UKQ P=GA BQHH =@R=JP=CA KB PDA QJEPO BA=PQNAO
1DA >KKGHAP EO KNC=JEVA@ =O BKHHKSO
1DA BKHHKSEJC BECQNAO =NA ODKSJ KJ L=CAO  =J@ ġ
!AO?NELPEKJ KB "=?D KILKJAJP
/AIKPA ?KJPNKH Ġ>QPPKJO
1DAU SEHH DAHL UKQ BEJ@ PDA >QPPKJO =J@ QJ@ANOP=J@ PDA OUI>KHO @EOLH=UA@
&J PDA I=JQ=H UKQ SEHH BEJ@ = OANEAO KB OPAL>UOPAL LNK?A@QNAO BKN A=?D BQJ?PEKJ
=R=EH=>HA
1DA EHHQOPN=PEKJO EJ PDA OPAL>UOPAL LNK?A@QNAO QOA BKQN @EBBANAJP OUI>KHOġ

E-7
Inserting the Remote Control Batteries
Push the battery cover on the rear of the remote control with your thumb
in the direction of the arrow and remove it.
Insert the two batteries, taking care to respect the polarities :
X+ on the battery with + on the remote control.
X- on the battery with - on the remote control.
1
2
Close the cover by sliding it back until it clicks into place.
3
XUse two AAA, LR03 1.5V batteries.
XDo not use old batteries or different kinds of batteries together.
XBatteries may be completely discharged after 12 months, even
if they have not been used.
You must insert or replace the remote control batteries when :
XYou purchase the air conditioner
XThe remote control does not work correctly
±

18 C 30 C
C
I higher than the selected temperature,
the air conditioner starts cooling
It will begin to cool after three minutes
is displayed.
You must select the Cool mode if you wish to lower the temperature
in your room. You can also set the Fan speed.
Remote Control Control Panel

E-9
Airing Your Room
Remote Control Control Panel
If you want to provide air circulation without cooling, you can use
the Fan mode.
If necessary, press the (On/Off) button.
Result: The Air Conditioner starts up in Cool mode .
The unit beeps twice.
2
To set the Fan Speed:
Press the , or button on the Remote control as desired.
or
Press the button on the unit one or more times until the
desired Fan Speed(F1, F2 or F3) is displayed.
4
To control the direction of the air flow, refer to page 11.
5
If the Fan Speed(F1, F2 or F3) is not displayed on the control panel:
Press the button on the remote control
or
Press the button on the unit one or more times until the Fan Speed
(F1, F2 or F3) is displayed.
Result: The unit beeps each time you press the / button.
The Air Conditioner starts up in Fan mode.
You can change modes at any time.
When the Air Conditioner is in Fan mode, the temperature
cannot be set or displayed.
3
Mode
Cool/Dry/Fan
Fan Speed
Mode
Cool/Dry/Fan
1 If you wish to evacuate stale air outside, push the ventilation lever on the
front of the unit to the right and the open position ( ).
Result: The air inside the room circulates and stale air is evacuated
outside.
Otherwise, push the ventilation lever to the left and the closed
position ( ).
Result: The air simply circulates inside the room.

E-10
Removing Excess Humidity

Remote Control Control Panel
If the temperature is not displayed on the control panel:
X Press the button on the remote control
or
X Press the button on the unit one or more times until is displayed.
Result:
X The unit beeps each time you press the / button.
X The air conditioner starts up in the Cool mode.
±
You can change modes at any time.
2
If the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
1If necessary, press the (On/Off) button.
Result:XThe air conditioner starts up in the Cool mode.
XThe unit beeps.
The air conditioner is fitted with a protection mechanism to pre-
vent the unit from being damaged when it is started immediately
after being:
XPlugged in
XStopped
It will begin to cool after three minutes.
3To adjust the temperature, press the
or buttons one or
more times until the required temperature is displayed.
The temperature can be set between
18°Cand 30°C .
Result:XEach time you press the
or buttons:
- The temperature is adjusted by 1°C
- The unit beeps
XThe air conditioner starts removing the excess humidity;
the quality of air is adjusted automatically.
4To control the direction of the air flow, refer to page 11.

E-11
Adjusting the Air Flow Direction Horizontally
Depending on the position of the unit in your room, you can adjust
the orientation of the inner air flow blades on the unit.
Adjust the inner air flow blades to the desired position by sliding them side to side.
$GMXVWLQJWKH$LU)ORZ'LUHFWLRQ9HUWLFDOO\
The outer air flow blades can be adjusted to control the vertical air
flow direction.
RECOMMENDATION :KHQ
&RROLQJ
$GMXVWWKHEODGHVWRIDFH
8SZDUGV
$GMXVWWKHouter DLUIORZEODGHVWRWKHGHVLUHGSRVLWLRQE\SXVKLQJWKHP
XSZDUGVRUGRZQZDUGV
,I\RXpositionWKHouter DLUIORZEODGHVGRZQZDUGwhile theXQLW
operates LQ&RROPRGHIRUORQJSHULRGVRIWLPHGHZPD\
 )RUPRQWKHVXUIDFHRIWKHEODGHV
 'ULSIURPWKHEODGHV
®

/AIKPA KJPNKH KJPNKH -=JAH
7KH$LU&RQGLWLRQHUUHWXUQVWRWKHSUHYLRXVO\VHOHFWHGRSHUDWLRQPRGH

/AIKPA KJPNKH KJPNKH -=JAH
WRWKHIDQVSHHGPRGHWKH2IIWLPHUPRGHLVFDQFHOHG

To Cancel the Good Sleep Mode
The Good Sleep mode can be used when you are cooling your room to
switch the air conditioner off automatically after 8 hours.
The Good Sleep function can be set whether the air conditioner is
switched on or off,and this function can be selected for any mode.
If Good Sleep is selected after switching on the unit ,the
air conditioner will run in Cool mode.During this period, the
temperature displayed is one you set for the Cool mode.
If the Good Sleep is selected before switch on the unit,
the air conditioner starts running in Cool mode and the
temperature is set to 26 °C.
If you no longer wish to use the Good Sleep mode that you have set,
you can cancel it at any time.
To cancel a selected Good Sleep mode,you can also press the
If you select the Energy Saving mode in the Good Sleep mode,
the Good Sleep mode will be canceled and the air conditioner
will start up in the Energy Saving mode.
Selecting Good Sleep Mode

E-15
Selecting Energy Saving Mode
To select the energy saving mode, press the button on the remote
control or button on the unit one or more times until the Energy
Saver indicator lights up.
Result: The fan and compressor cycle on and off together.
The fan will continue to run for a short time after the
compressor cycles off.
If you would like the air conditioner to run in Dry mode, do not press
the button. You cannot use the Dry mode in the energy saving
mode.
To stop the energy saving mode, press the button on the remote
control or button on the unit again.
Result: The fan runs at all times, while the compressor cycles on and off.
If you select the Good Sleep in the Energy Saving mode, the Energy
Saving will be cancelled and the air conditioner will start up in the
Good Sleep mode.
If you wish to save energy when using your air conditioner,
select the energy saving mode.
1
2
E.Saver
E.Saver
E.Saver
E.Saver
E.Saver
Remote Control Control Panel

(
7HPSHUDWXUHDQG+XPLGLW\5DQJHV
,IWKHDLUFRQGLWLRQHULVXVHGDW 7KHQ
+LJKHUWHPSHUDWXUHs7KHDXWRPDWLFSURWHFWLRQIHDWXUHPD\EHWULJJHUHGDQGWKHDLU
FRQGLWLRQHUZLOO VWRS
/RZHUWHPSHUDWXUHs$ ZDWHUOHDNDJHRUVRPHRWKHUPDOIXQFWLRQPD\KDSSHQLIWKH
KHDWH[FKDQJHUIUHH]HV
+LJKHUKXPLGLW\OHYHOV :DWHUPD\FRQGHQVHRQDQGGULSIURPWKHVXUIDFHRIWKHXQLW
LILWLVXVHGIRUORQJSHULRGV
7KHIROORZLQJWDEOHLQGLFDWHVWKH DLU FRQGLWLRQHUV WHPSHUDWXUHDQGKXPLGLW\ RSHUD WL R Q UDQJH
0RGH ,QGRRU7HPSHUDWXUH 2XWGRRU7HPSHUDWXUH ,QGRRU+XPLGLW\
&RROLQJ 21CWR32CDSSUR[ 21CWR43CDSSURx. 8RUOHVV

(
%NGCPKPI;QWT#KT%QPFKVKQPGT
IURQWJULOOH IURQWJULOOH
IURQWJULOOH
DLU
ZLWFK RQ
ZLWFK RQ

Technical Specifications
Design and specifications are to change without notica
Model Voltage &
Frequecy Capacity Power
Consumption
Operating
Current
AW08NHAA 115V~, 60Hz 8000 BTU/h 820W 7.4A
AW08NHAB 115V~, 60Hz 8000 BTU/h 820W 7.4A
AW08NKAF 115V~, 60Hz 8000 BTU/h 760W 6.7A

Checkpoints prior to installation
1 Check the cabinet and front grille of the unit for any harmful defects
such as scratches.
2 Be sure to check the power supply.
- Refer to the specifications on the label attached to the unit.
Before installation, be sure to check the installation area or the air
conditioner, and drain hose.
Installation Conditions
1 As the unit is heavy, the wall or window of the installation area should
have sufficient strength and durability for operation of the air conditioner,
and for prevention of any vibration or noise.
If it is weak, reinforcement work should be performed separately.
2 It is advisable to install the air conditioner in the north or west side to
prevent the effect of direct sunlight.
When installing it in the south or east side due to unavoidable
circumstances, it is advisable to install the sunshade to prevent the
direct sunlight.
In this case, take care not to cause any hindrance to the flow of outside air.
3 When installing the air conditioner, be sure to obtain sufficient space on
the rear side of the unit for smooth flow of air.
When operating the air conditioner in closed areas such as inner building
with cooling operation, and result in trouble with the unit.
See the illustration below.
65mm
min.
300mm
500mm
110mm min.
Approx.3˚
Awning
750mm
45
45
Outdoor side
Indoor side
100mm or more
500mm 500mm
Installation
If the wall is greater than 110mm thick,
cut the wall back on a 45 angle if possible.
MODEL “A”
AW08NH
145
170
AW08NK
“A”

Rubber cap
Screws(2EA)
Gasket
Rear
Drain Tube
Installation of the Drain Tube
Fix the drain tube as shown in the figure.
E -20
Installation(Continued)