COLOR CCD CAMERA User’s Manual
19
COLOR CCD CAMERA User’s Manual
18
SHUTTER : Because of using built--in dc lens, shutter speed is fixed at 1/60(50)
basically.
- A.FLK : Select this when you experience picture flicker, which can happen when there
is a clash with the frequency of the installed lighting.
AGC (AUTO GAIN CONTROL) :
The higher the gain level, the brighter the screen - but the higher the noise.
- OFF : Deactivates the AGC function.
- LOW : Allows automatic gain control from 5.3dB to 32dB.
- HIGH : Allows automatic gain control from 5.3dB to 37dB.
SENS-UP :
When it is night or dark, the camera automatically detects the light level and maintains
a clear picture if this mode is activated.
- OFF : Deactivates the SENS-UP function.
- AUTO : Activates the SENS-UP function.
• When the SHUTTER is set to MANUAL or A.FLK mode, SENS-UP will be disabled.
Notes
RETURN : Select this to save the changes in the EXPOSURE menu and return to the
SETUP menu.
• If you press the SET button in ‘AUTO’ mode, You can adjust brightness by increasing
or decreasing the shutter speed. (X2~X256)
• Note that the higher the zoom level, the brighter the screen, but the more likely it is that
an after-image will appear.
• Although Noise, Spots, and Whitish symptoms may occur in SENS-UP operation when
the zoom level is increased, this is normal.
Notes
Use the White Balance function to adjust the screen color.
1. When the SETUP menu screen is displayed, select ‘White Bal.’ by using the Function
Setup switch so that the arrow indicates ‘White Bal.’ .
2. Select a desired mode using the Function Setup switch.
White Balance (White Bal.)
MAIN SETUP
1.LENS DC
2.EXPOSURE
3.WHITE BAL ATW
4.BACKLIGHT OFF
Select one of the following 5 modes, as appropriate for your purpose.
ATW : Select this when the color temperature is between 1800˚K and 10500˚K
INDOOR :
Select this when the color temperature is between 4500˚K and 8500˚K.
OUTDOOR : Select this when the color temperature is between 1800˚K and
10500˚K. (sodium light inclusion)
AWC SET :
To find the optimal setting for the current luminance environment in this
mode, set the point the camera towards a sheet of white paper and press the
SET button. If the environment changes,
readjust it.
MANUAL :
Select this to fine-tune White Balance
manually. Set White Balance first by using
the ATW or AWC mode. After that switch to
MANUAL mode, fine-tune the White Balance
and then press the
Function Setup switch
.
• White Balance may not work properly under the following conditions. In this case select
the AWC mode.
When the color temperature of environment surrounding the subject is out of the control
range (e.g. clear sky, or sunset)
When the ambient illumination of the subject is dim.
If the camera is directed towards a fluorescent light or is installed in a place where illumination
changes dramatically, the White Balance operation may become unstable.
Notes
Operating Your Camera
