Samsung SCX-DO300 User manual

Outdoor Housing
SCX-DO300
imagine the possibilities
Thanks you for purchasing this Samsung product.
To receive a more complete service, please
register your product at
www.samsungsecurity.com
ENG.indd 1 2009-10-12 15:27:54

2_ SCX-DO300
OVERVIEW
The Outdoor Housing (SCX-DO300) is a Housing used to install the SMARTDOME CAMERA
(SCC-C6455/C6453) on an outdoor wall or ceiling.
PRECAUTIONS
Select an installation spot which can endure more than 4 times of the product weight.
If you install this product in a low-temp area such as inside a cold store, you must seal up
the wiring pipe with silicon, so that the external air can not flow inside the housing.
Otherwise, external high, humid air may flow inside the housing, pooling moisture or
vapor inside the product due to a difference between internal and external temperature.
When installing, prevent peoples approaching to avoid personal injury. Move valuables to
a safer place before installing.
When the unit is stored in high humidity environment, moisture may occur inside the
cover dome of the Housing. Before installation, please open the cover dome and wipe off
all moisture with a soft dry cloth.
OPTIONAL ACCESSORIES FOR INSTALLATION
Install OUTDOOR HOUSING using the provided adaptor according to the place for
installation.
Install the Adapter below according to the installation guide of each product.
①CEILING MOUNT ADAPTOR(SCX-300CM) : For installation on a ceiling.
②WALL MOUNT ADAPTOR(SCX-300WM) : For direct installation on a wall.
③POLE MOUNT ADAPTOR(SCX-300PM) : For installation on a cylindrical pole.
The Wall Mounted Adaptor(SCX-300WM) is also used in conjunction with the Pole
Mounted Adaptor.
④CORNER MOUNT ADAPTOR (SCX-300KM) : It is used when the camera is installed
on a corner of the wall.
The WALL MOUNTED ADAPTOR (SCX-300WM) is also used in conjunction with
the Pole Mounted Adaptor.
⑤PARAPET MOUNT ADAPTOR(SCX-300LM) : Use this if you install the product on the
internal wall of a building roof and locate the camera outdoors.
1.
2.
3.
4.

-
-
ENG.indd 2 2009-10-12 15:27:55

SCX-DO300 _3
●eng
PREPARATION
Run all the external cables through the bracket adaptor’s PIPE or MOUNT hole. Wrap
around the HOUSING’s screw hole with the Teflon Tape.
PIPE OR
MOUNT
1.5" PT
EXTERNAL
CABLE
1.5" PT
TEFLON TAPE
HOUSING
ENG.indd 3 2009-10-12 15:27:56

4_ SCX-DO300
INSTALLATION
Press the SNAP FIT of the ADAPTOR in the HOUSING to open the ADAPTOR part,
and then insert all external cables into the HOUSING. Secure the HOUSING on the PIPE
or MOUNT by turning it clockwise.
(Secure two components tightly, to avoid loosened HOUSING.)
1.
PIPE OR
MOUNT
HOUSING
EXTERNAL
CABLE
ADAPTOR
SNAP-FIT
PIPE OR
MOUNT
HOUSING
Make sure you fix the Pipe or Adaptor so that it reaches to the end of the 1.5” NPT screw thread
on the Outdoor Housing. If not secured tightly, the Outdoor Housing may loosen from the Pipe
or Adaptor, causing physical damage or malfunction. (Make sure you check the connection
between two components before proceeding with the next step.)
M
ENG.indd 4 2009-10-12 15:27:59

SCX-DO300 _5
●eng
Connect external cables to the CONNECTORS(ALARM IN, POWER, RS-485, ALARM
OUT) and connect the CONNECTOR to the ADAPTOR.
Insert the cable into the FRAME SET, and close the ADAPTOR.
Then, wrap the BNC JACK with the INSULATION TUBE, and use an insulation tape
to seal up the end of the INSULATION TUBE so that the BNC JACK does not
protrude outside of the INSULATION TUBE coating.
For more information about cable connection, refer to Connecting the adaptor cable in the
CAMERA’s Instruction book.
2.
M

ALARM OUT
ALARM IN RS-485
POWER INPUT
HOUSING
EXTERNAL
CABLE
ADAPTOR
BNC JACK
INSULATION
TUBE
ENG.indd 5 2009-10-12 15:28:02

6_ SCX-DO300
Note that BUSHINGs are provided for outdoor installations where exposed to a moisture
condition through the PIPE or MOUNT, install the HOUSING using the BUSHING to
prevent moisture entering.
- Apply grease of proper dose on the BUSHING before assembling, and run cables
through each hole of the bushings. Use PINS to stop up empty holes having no cable
running.
- Assemble the BUSHING to the top side of HOUSING’s inside as shown in the
diagram below. At the moment, apply pressure evenly on the BUSHING to secure it
tightly to the HOUSING as shown in the diagram.
BUSH
BUSH ETC CABLE
POWER (24V)
CABLE
BNC CABLE
BUSH
BUSH
PIN

BUSH
HOUSING
PIPE OR
MOUNT
BUSH
HOUSING
ENG.indd 6 2009-10-12 15:28:05

SCX-DO300 _7
●eng
Prepare the CAMERA to be installed.
Tie up the SAFETY WIRE of the CAMERA on the BRACKET WIRE of the FRAME SET.
Arrange the 22P CONNECTOR of the CAMERA in line with that of the ADAPTOR, push
the HOOKs on either end of the CAMERA in the RACK direction of the FRAME SET to
secure the two.
Then, ensure that all of the two HOOKs clicks to fix to the RACK properly.
3.
22P CONNECTOR HOUSING
RACK
RACK
BRACKET WIRE
FRAME SET
SAFETY WIRE
HOOK
HOOK
CAMERA
PROTECTIVE COVER
PROTECTIVE TAPE
When the installation is completed, remove the PROTECTIVE COVER and PRETOECTIVE
TAPE from the lens.
M
ENG.indd 7 2009-10-12 15:28:08

8_ SCX-DO300
Align each of the 3 SCREWS of COVER DOME and 3 SCREW HOLEs of the
HOUSING respectively, and assemble the COVER DOME and HOUSING. During the
assembling, note on the followings.
Insert and arrange SAFETY WIRE into the HOUSING while not disturbing the
camera operation.
Ensure that the GASKET DOME component does not separate from the COVER
DOME. (If the GASKET DOME is not properly assembled, it damages the
waterproofness.)
4.


SCREWS
HOUSING
COVER DOME
COVER DOME
GASKET DOME
CAMERA
HOUSING
SAFETY WIRE
For the information about Camera setup and operation, please refer to Camera's Instruction
book.
M
ENG.indd 8 2009-10-12 15:28:10

SCX-DO300 _9
●eng
PRODUCT SPECIFICATION
Size : Ø228 X H256 mm
Weight : 2.5 Kg
Power source: AC24V (50Hz) (Use an adaptor over 3A when the heater works.)
Power Consumption: 16.3W (Camera, Fan)/47W (Heater on)
Operation Temperature : -50˚C(absolute minimum) ~ 50˚C
Operation Humidity : 0~90%
Fan Operation Temperature : Unlimited
Heater Operation Temperature : Below 10˚C
ACCESSORIES
Bush .......................................1
Pin .........................................1
Silicon Grease .........................5g
Manual ....................................1
256mm
240mm
Ø216mm (Housing Body)
Ø228mm (Shield Sun)
ENG.indd 9 2009-10-12 15:28:11

Correct Disposal of This Product (Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems)
This marking on the product, accessories or literature indicates that the product and its electronic
accessories (e.g. charger, headset, USB cable) should not be disposed of with other household waste
at the end of their working life. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, please separate these items from other types of waste and recycle them
responsibly to promote the sustainable reuse of material resources.
Household users should contact either the retailer where they purchased this product, or their local
government office, for details of where and how they can take these items for environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions of the purchase contract.
This product and its electronic accessories should not be mixed with other commercial wastes for disposal.
ENG.indd 10 2009-10-12 15:28:11