Sandleford KSS122 User manual

WALL-MOUNT
KEY SAFE
KSS122
Operating Instructions
KEY SAFE INSTRUCTIONS
ATTENTION
Please read the operating instructions carefully
before you operate the lock or try to set a new
combination of numbers. We can not accept
any liability for malfunction due to the setting of
the combination being carried out incorrectly.
We can not accept any liability for any damage
or for loss of property. The product is used
entirely at the owner’s risk.
FIRST OPENING
1. Slide the Shutter Door to reveal the dials
and Open Latch
2. Rotate the dials to the pre-set factory
combination 0-0-0-0
3. Push the Black Open Latch downwards
4. Pull the door fully open
SET YOUR CODE
1. Open the Key Box (refer instructions above)
2. Choose your 4 digit code
3. With the Key Box Internal Door facing you
(the Reset Button should be on the Right Side),
push the RESET Lever on the back of the door to
the left and downward
LOCKING YOUR SAFE
1. After closing your safe door (as above)
you lock the safe by spinning the dials to
dierent numbers than your set code.
2. Test the Safe is locked by pulling the Black
Latch downwards – if locked it will not move
downwards and the door cannot be opened.
OPENING YOUR SAFE
1. Rotate dials to your set combination
2. Push the Black Open Latch downwards
3. Pull the door fully open
Important
1. Keep the Shutter Door Closed to protect
against weather
2. We do not recommend setting codes such as
1-2-3-4 or 2-2-2-2 Random codes will
provide greater security
3. It is recommended to rotate the dials weekly
to keep them moving freely
4. Rotate the dials to your desired combination –
Ensure they are aligned correctly so the code is
entered accurately
5. Push the RESET Lever upward and to the right
(Back to its original position. Check the Lever is fully
back to its original position and it is flush against
the side.
6. Close the door
7. Test your code is set correctly by pushing the
Black Open Latch Downwards to open
Push the
Black Open
Latch
downwards
Right Side Left and Downward

PARTS LIST
INSTALLING YOUR SAFE
FIXING TO BRICK
Mark holes, drill 4x6mm holes, insert wall plugs.
Insert screws into back panel & screw into wall plugs.
FIXING TO TIMBER FENCE
Insert screws into back panel & screw into wall plugs.
Sandleford Holdings will not accept
or be responsible for any loss or
damage caused in the event of theft
or unauthorised use”
Shutter Door
Safe Body
Mounting
Holes
Code Dials
Open latch
Tel [phone]