Sanosil Q-Jet User manual
Use of Sanosil Q-Jet in buildings
for aerosol disinfection
Nosocominal Infections
Nosocomial infections are among
the most dreaded risks in modern
medicine. Not least due to the
prevalence of antibiotic-resistant
germs.
Gap in effectiveness
Manual cleaning and disinfection reach
only 80 –90% of potentially contami-
nated surfaces.
A risky gap in effectiveness remains!
Perfect 3D Hygiene
An additional aerosol disinfection closes
this effectiveness gap and achieves
perfect 3D hygiene!
Aerosol Disinfection in 8 Easy Steps:
How should one carry out a
perfect aerosol disinfection?
1. Empty Room
Make sure that the room to be treated is
empty and does not need to be used
for several hours!
2. Pre-Disinfection
Clean the room thoroughly and
disinfect all contact points and
critical surfaces manually by wiping
them down.
3. Prepare Room
Close windows, doors, hatches etc.,
switch off air conditioning and
ventilation.
4. Prepare Q-Jet Device
Position the machine.
Observe the prescribed safety
distance (3 –6 m, depending on
the spray setting) to walls, ceiling
and equipment.
20 -22°C 40% rH
5. Aerosol Disinfection Action
Nebulise the necessary amount of
Sanosil S015.
Make sure that 80% rH is not
exceeded to avoid condensation.
6. Wait for reaction time
Allow the fog to work for at least 2
hours (prefer-ably overnight).
Do not enter the room during this
time.
7. Prepare for Room Re-use
Make sure the hydrogen peroxide
level is < 1ppm before the room is
used again. Otherwise, ventilate the
room thoroughly.
H2O2Level: < 1 ppm
8. Be safe again
The room can be used again with
perfect 3D hygiene!
BEST WITH:
Sanosil Q-Jet and Sanosil S015
Other Sanosil Medical Equipment manuals
