Sanyo PDP-32H1EV User manual

FILE NO.
Notice
CORRECTION ●PRODUCTION CHANGE
SERVICE FLASH ADD INFORMATION
REVISION-1
Please add this notice to the Service Manual listed below.
Category : Multi-media Plasma Monitor Issued Date : Mar / 2002
PDP-32H1EV PDP-32H1E-00
Model : PDP-32H1A Effective from : Chassis No. J3D-32H1A00
Europe, U.K.
Destination : Canada, U.S. Asia REF. NO. : SM5110287
NOTE: Match the Chassis No. on the unit’s back cover with the Chassis No. in the Service
Manual.
If the Chassis. No. does not match the unit’s, additional Service Literature is
required. Only the Difference Service Information is given in this manual. For detail
Service Information, Refer to the Original Service Manual SM5110287, issued in
December 2001, for Models PDP-32H1EV, PDP-32H1A.
PRODUCT CODE
1 114 016 00 PDP-32H1EV, J3DH
1 114 035 00 PDP-32H1A, J3DFB REFERENCE NO. SM5110287-01
FILE WITH ORIGINAL SERVICE MANUAL (SM5110287)
Differences
ACCESSORY & CHASSIS ELECTRICAL PARTS LIST (Refer to the back page.)
The Reason of change. A: Misprint B: Quality Reliabilities C: Standardization D: Design
Page Key No. Part No. Description Q’ty Interchange-ability Reason
Before SXTG RC TRANSMITTER 1 No
40
After 645 049 5359 ASSY, REMOCON SXTG 1 No
A
Add 645 002 9189 CORD, POWER-3.0MK,UL 1 No
EL901 Before 645 051 9086 PDP MODULE 1 No
42
EL901 After 645 054 8710 PDP MODULE (WO/ POWER UNIT) 1 No
D
U901 After 645 054 3784 (PANEL) POWER UNIT 1 No
(A) After 411 036 5301 SCREW 3X6 7
(B) After 645 050 3665 FLAT CABLE 1
(C) After 645 002 7888 WIRE BAND (V0-100) 1
!
!
!
!
Mar./2002
●

■Modification of Explanation
-2-
KKK
Do not remove Panel only.
For changing Panel, it is necessary to change
these all units (except Power Unit) too.
Refer to parts list.
Attention
Below 3Units are included with Panel for PDP Module. Do not remove from Panel.
For changing Panel, it is necessary to change these all units too.
!
Modification Page: P16 of Original Service Manual
Panel Power Unit
This is not included in Panel Module.
For changing Panel Module, remove and use it.
X
A
A
A
A
B
C
■ Panel Power Unit Replacement
1. Remove 7 screws (A).
2. Cut and remove the wire band (C).
3. Remove wires connected to Panel Power Unit.
4. Remove the Flat Cable (B).