Sapa Redd Team Dura-Grip General Code User manual

Dura
Dura- -Grip Grip General Code General Code
System Assembly
System Assembly
General Compliance
Dura-Grip
Modular Building Access

General Code
General Code
Platform Components
Platform Components
Legs
Platform
Platform
Cone
Hardware
Bag
Leg Pads

Stair Riser
Guardrail
General Code
General Code
Stair Components
Stair Components
Hand rails
Riser Plate

1. Insert legs into
platform cones,
with leg pads facing
inwards
2. Using the 2.5” Hex
Head Cap Screws,
finger tighten at
following heights,
from platform
surface to leg pad:
28”- 3 Step System
35” - 4 Step System
General Code
General Code
Stair Assembly
Stair Assembly

3. Flip platform
upright and
bring to
threshold
General Code
General Code
Stair Assembly
Stair Assembly

4. Adjust the height of
the legs so that the
system is flush with
threshold - use dirt
or plates under leg
pads to level the
platform if needed
General Code
General Code
Stair Assembly
Stair Assembly

5. Attach stair riser with
4.5” Hex Head Screws
for sides (shown
below) and #10-3/4”
Hex Head Tek Screws
for the Riser Plate
General Code
General Code
Stair Assembly
Stair Assembly

5. Lag platform to
building with (3)
¼” x 3” Lag
Screws, through
holes provided
on landing
General Code
General Code
Stair Assembly
Stair Assembly

6. Insert both
guardrails so
that they rest on
the ¼” x 4 ½”
bolts previously
inserted
General Code
General Code
Stair Assembly
Stair Assembly

7. Connect Landing
Rail Clip to
landing rail using
(2) #14 x 3/4”
Hex Head Tek
screws - then
connect clip to
building using
(2) ¼” x 2” Lag
Screws
General Code
General Code
Stair Assembly
Stair Assembly

8. Connect
guardrails
together with
Corner Clip
angle using
(2) #14 x ¾”
Hex Head Tek
Screws
General Code
General Code
Stair Assembly
Stair Assembly

9. Install the stair
rail by inserting
the bottom of rail
into platform
cone then top -
make sure that
the rails sit on
the ¼” x 4 ½”
bolts
General Code
General Code
Stair Assembly
Stair Assembly

10. Connect Landing
Rail to Stair Rail
using stair corner
clip angle and (2)
#14 x 3/4” hex
head Tek screws
General Code
General Code
Stair Assembly
Stair Assembly

11. Connect Stair Rail to
Landing Rail Clip
using (2) #14 x 3/4”
Hex Head Tek screws
- then connect clip to
building using (2)
¼” x 2” Lag Screws
General Code
General Code
Stair Assembly
Stair Assembly

General Code
General Code
Stair Assembly
Stair Assembly
12 Make sure ground
is level at bottom
of first riser - add
or remove dirt as
necessary - must
maintain a 7”
riser height to
remain within
code compliance

General Code
General Code
Stair Assembly Complete
Stair Assembly Complete