
SARINEnergy.com
855-997-2746
LED@SARINEnergy.com
Commercial UVC Sterilizer
Model: Commercial UVC Sterilizer
Size: 21.6”(L) x 7”(W) x 7”(D) 2.9 lbs
Power: 55W
Voltage: AC90 - 100V
UV Strength: ≥253.1 µW/cm2 (at 3.5 ft)
Effective Range: ~650 ft2
UVC Wavelength: 253.7 nm
UVC Lamp: Mercury Fused Silica
Bonus Features: Motion Detector, Remote
Bulb Lifespan: ≥8,000 hours
Remote Range: 22 ft
Plug in the device and place it in the center of the room about 40” away from the ground.
Make sure the area is clear and estimate the size of the room to determine cycle length.
FEATURES
SPECIFICATIONS
INSTRUCTIONS
TIPS & SAFETY
• To maximize effectiveness, ensure the
room to be disinfected is clear of debris
• Take care to avoid direct or prolonged
exposure of UVC to skin and eyes
• Keep out of reach of children and pets,
do not leave unattended while not in use
• Clear area of people, plants and animals
• Can be used near food, tests have not
shown any loss in quality or nutrition
• Set on a small stand like a tripod
• If the lamp breaks use a wet paper
towel to clean up, and do not inhale
• As distance from a subject is increased,
exposure time should be prolonged
1. Clinically proven to eliminate 99.9% of all viruses, bacteria, fungi, mold, yeast, algae,
amoebas, and other germs and allergens within seconds of 253.7 nm UVC exposure.
2. Can be programmed and set with touch panel or remote control.
3. A 360° motion sensor deactivates the lamp when it detects movement within 16 feet.
4. Contact-free disinfection reduces the chance of human error and cross-contamination.
5. Hypoallergenic sanitizing does not leave irritants or toxic chemicals behind.
6. Reduces the need to buy and handle corrosive cleaners. (Does not replace soap/water)
Area Disinfect Time
~225 ft215 minutes
~450 ft230 minutes
~550 ft245 minutes
~650 ft260 minutes
Manual Operation:
1. Plug in and power on.
2. Press “ON/OFF” button
on touch panel.
3. Using the “Time Setting”
button select your duration.
4. There is a 10 second delay,
then the light activates.
Remote Operation:
1. Plug in and power on.
2. Press “ON/OFF” button
on the remote control.
3. Select your duration using
a “Time Setting” button.
4. There is a 10 second delay,
then the light activates.
Motion Sensor: This activates 20 seconds after the lamp is switched on. When motion is
detected within 16 feet the light will turn off, then turn back on after 20 seconds of no motion.
To activate or deactivate the sensor, hold down the radar button on the unit until it chimes.
(ETL, FCC Pending)