Sarin Energy SES-UVCRM-38-W User manual

UVC Room Sterilizer
Ultraviolet Disinfection Light Kills 99.9%
of Viruses, Bacteria, Fungi & More

SARINEnergy.com
855-997-2746
[e-mail]
UVC Room Sterilizer
Disinfect in 15-60 min
~12 ft
(Maximum Effective Radius) ~12 ft (Maximum Effective Radius)
The Centers for Disease Control and Prevention (CDC) recommends a UV lamp intensity of 40 µW/cm2
at the center of the work area to ensure surface decontamination.

SARINEnergy.com
855-997-2746
[e-mail]
UVC Room Sterilizer
Viruses
Bacteria
Fungi
Mold
Yeast
Algae
Amoebas
Allergens
UVC Kills
17”
9”
Mercury
Quartz Lamp
360°
Motion
Sensor
6.3”
ABS
Housing
White: #10990 SES-UVCRM-38-W
Black: #10988 SES-UVCRM-38-B

SARINEnergy.com
855-997-2746
[e-mail]
UVC Room Sterilizer
Model: UVC Room Sterilizer
Size: 17”(L) x 9”(W) x 6.3”(D) 1.5 lbs
Power: 38W
Voltage: AC110 - 130V
UV Strength: ≥143 µW/cm2(at 3.5 ft)
Effective Range: ~450 ft2
UVC Wavelength: 253.7 nm
UVC Lamp: Mercury Quartz
Bonus Features: Motion Detector, Child Lock
Bulb Lifespan: ≥8,000 hours
Sensor Range: 13 ft
Plug in the device and place it in the center of the room about 40” away from the ground.
Make sure the area is clear and estimate the size of the room to determine cycle length.
FEATURES
SPECIFICATIONS
INSTRUCTIONS
TIPS & SAFETY
• To maximize effectiveness, ensure the
room to be disinfected is clear of debris
• Avoid UVC exposure to skin and eyes
• Keep out of reach of children and pets,
should be put away between uses
• Clear area of people, plants and animals
• Can be used near food, tests have not
shown any loss in quality or nutrition
• Set on a small stand like a tripod
• If the lamp breaks use a wet paper
towel to clean up, and do not inhale
• As distance from a subject is increased,
exposure time should be prolonged
• Skin oils can damage the bulb, don’t touch
1. Clinically proven to eliminate 99.9% of all viruses, bacteria, fungi, mold, yeast, algae,
amoebas, and other germs and allergens within seconds of 253.7 nm UVC exposure.
2. Can be programmed and set via button panel with child safety lock.
3. A 360° motion sensor deactivates the lamp when it detects movement within 13 feet.
4. Contact-free disinfection reduces the chance of human error and cross-contamination.
5. Hypoallergenic sanitizing does not leave irritants or toxic chemicals behind.
6. Reduces the need to buy and handle corrosive cleaners. (Does not replace soap/water)
Area Disinfect Time
~175 ft2 15 minutes
~300 ft230 minutes
~450 ft260 minutes
Manual Operation:
1. Hold the “Child Protection Lock” button for 3 seconds.
2. Press the button to set your time: “15min” “30min” “60min”.
3. The lamp beeps for 30 sec before it starts so you can exit.
4. To stop the process press the “Cancel” button.
5. To turn off the motion sensor hold “Cancel” for 5 seconds.
Motion Sensor: When the device is set there is a delay before
the light turns on, which happens 3 seconds after movement
is no longer detected. If anyone enters the area during
disinfection the light temporarily deactivates until they exit.