RESET INSTRUCTIONS FOR PC OR TV
1. Switch off power from wall outlet
2. Plug PC Standby Stop into wall outlet
3. Plug in computer, TV or any electric device with power
consumption less than 1000W in socket labeled ‘PC/TV’
4. Turn on power on wall outlet
5. Put device plugged into ‘PC/TV’ socket on standby
6. Reset to new standby power level by pressing the button
on the top of PC Standby Stop for 5 seconds until the
green indicator lights up for 2 seconds
7. Switch off power from wall outlet
8. Plug in accessories in sockets labeled ‘Accessories’
9. If a device needs permanent power, plug it into the
socket labeled ‘Permanent’
10. Turn on power from wall outlet - PC Standby Stop is now
ready for use
To test setup, turn on device plugged into ‘PC/TV’. After a short time
all devices plugged into sockets labeled ‘Accessories’ should receive
power. Put device plugged into ‘PC/TV’ on standby. After a short
time all devices plugged into sockets labeled ‘Accessories’ should
shut off. If not, repeat 1–10.
Permanent - to use with device,
that requires permanent power
Computer, TV or any electric
device less than 1000W. Standby
power level is measured from
this socket
Green light indicates when
standby power level is set. Red
light indicates that the overvolt-
age fuse has blown and that the
product must be discarded and
replaced
Press button to set standby
power level - lamp indicates
when standby power level is set
Accessories - power is shut off
when device connected to ‘PC/
TV’ socket is shut off or put on
standby
RESET INSTRUCTIONS FOR LAPTOP COMPUTER
1. Plug PC Standby Stop into wall outlet
2. Turn on power on wall outlet
3. Reset to default standby power level by pressing the button
on the top of PC Standby Stop for 5 seconds until the green
indicator lights up for 2 seconds
4. Switch off power from wall outlet
5. Plug laptop computer into socket labeled ‘PC/TV’
6. Plug accessories into sockets labeled ‘Accessories’
7. If a device needs permanent power, plug it into the
socket labeled ‘Permanent’
8. Turn on power from wall outlet - PC Standby Stop is now
ready for use
To test setup, turn on laptop computer. After a short time all
devices plugged into sockets labeled ‘Accessories’ should receive
power. Wait until the batteries of the laptop computer are fully
charged and put laptop computer on standby. After a short time
all devices plugged into sockets labeled ‘Accessories’ should shut
off. If not, repeat 1–8.
Note that on some laptop computers, charging the batteries will
cause accessories to receive power even if computer is put on
standby. When batteries are fully charged, PC Standby Stop will
automatically shut off power for accessories.
1
678
97
4
23
5 5 2
4
5
6
1
3
Universal Elspareskinne
TV
PC & MacBærbar
Permanent strøm
Tilbehør
DVD
(1-19W)
Skærm
(1-8W)
Printer
(4-10W)
Modem
(4-13W)
Satellit modtager
(5-30W)
Spillekonsol
(18-80W)
Universal Elspareskinne
TV
PC & MacBærbar
Permanent strøm
Tilbehør
DVD
(1-19W)
Skærm
(1-8W)
Printer
(4-10W)
Modem
(4-13W)
Satellit modtager
(5-30W)
Spillekonsol
(18-80W)
Universal Elspareskinne
TV
PC & MacBærbar
Permanent strøm
Tilbehør
DVD
(1-19W)
Skærm
(1-8W)
Printer
(4-10W)
Modem
(4-13W)
Satellit modtager
(5-30W)
Spillekonsol
(18-80W)
Universal Elspareskinne
TV
PC & MacBærbar
Permanent strøm
Tilbehør
DVD
(1-19W)
Skærm
(1-8W)
Printer
(4-10W)
Modem
(4-13W)
Satellit modtager
(5-30W)
Spillekonsol
(18-80W)
ACCESSORIES ACCESSORIES
TV/PC
LAPTOP
OFF
STANDBY
PRESS 4–5 SEC.
FLASh
PRESS 4–5 SEC.
FLASh
Universal Elspareskinne
TV
PC & MacBærbar
Permanent strøm
Tilbehør
DVD
(1-19W)
Skærm
(1-8W)
Printer
(4-10W)
Modem
(4-13W)
Satellit modtager
(5-30W)
Spillekonsol
(18-80W)
