212-0024-6SS 4July 30th, 2019
Warning
1. The use of emergency warning devices does not ensure the safety of the operator. The operator is
responsible to ensure safe operaon of the vehicle regardless of whether the warning device is in
operaon or not
2. The eecveness of this or any warning device is highly dependent on proper installaon and
maintenance. Read the manufactures instrucons before installing and follow all recommenda-
ons.
3. When in use the operator must ensure that the warning signal is visible and not obstructed by vehi-
cle components (i.e. open trunk lid), people or other obstrucons
4. This device is intended for use by authorized personnel only. It is the responsibility of the user to
ensure that all local, state, provincial and federal laws are being complied with. D&R assumes no
liability for any loss resulng from the use of this device.
5. The device must be installed so as not to reduce the output performance of vehicle systems.
6. Placement of control switches must be so as to provide convenient reach for the operator without
loosing eye contact with the road.
7. Emergency warning devices require high electrical voltages and/or currents. Properly connect and
ground all circuits. Shorng or improper grounding of this device may caused personal injuring, ve-
hicle damage and/or device damage.
8. All operators should be properly trained in the operaon of this device to ensure both operator and
public safety
9. Any device used inside a vehicle, may cause severe personal injury if not properly mounted and
secured. Objects used in the vehicle may become airborne during a collision or other sudden chang-
es in vehicle speed or direcon, such as braking, acceleraon or turns.
10. Be sure to mount unit through the steel of the vehicle. Avoid mounng through plasc or other non
-structural materials.
11. POINT OF INSTALLATION MUST NOT INTERFERE WITH DEPLOYMENT OF VEHICLE AIR BAGS.
12. D&R Electronics recommends that this and any of our other products be installed by qualied per-
sonnel.
13. Good wiring pracces and thorough knowledge of vehicle power systems is required by the installer
of this and any other product.
14. Looms, grommets, cable es or other installaon hardware should be used to anchor and protect
wiring.
15. All wire sizes must meet the minimum sizes specied by the manufacturer.
16. Splices should be minimized and made in a fashion so as to protect from moisture which could
cause corrosion thereby reducing conducvity.
17. The exact number of available connecons varies by applicaon. Refer to the specicaons and
typical output fusing combinaons to ensure that the safety and reliability of this product is not
compromised.
Warning
Maintenance
The PDU-16SS does not require user maintenance except for the individual fuse replacements.
Do not aempt to open or repair.
Contact your local distributor or D&R Electronics for repair.
