Sawo 505-IR-A User manual

MANUAL
ENGLISH
INFRARED BACKREST
IR Emitter
ON/OFF Switch
Plug
Head Rest
Back Rest
Not for use in the USA, Canada and Mexico.

SAFETY INSTRUCTIONS
Please take note of these safety precautions before using the infrared backrest.
Infrared backrest must be used with caution.
• Read the manual for additional important instructions.
• Children or people with mental disabilities must have
adult supervision when using the infrared backrest.
• Under no circumstances should children be allowed to
play with the device.
• Overexposure may have adverse effect to the body.
• Make sure that the infrared emitter is not directly
hitting to your head.
• Do not use when you are suffering from sunburns, skin
deceases or undergoing photosensitivity treatments.
• Refrain from using the infrared backrest when any of
its components are broken.
• Back of the infrared backrest must always be open for
a proper airow. Do not place any obstruction at the
back of the emitter as it may overheat.
• Never throw water into the infrared backrest as it may
cause damage.
• Unplug the device when not in use.
• Covering the IR panel causes re hazard.
• If the supply cord is damaged, it must be replaced by
the manufacturer or its qualied service agent to avoid
hazard.

NOTE!
Intended for the back only.
ON and OFF switch.
INSTRUCTIONS
The infrared backrest can be used in the ofce or other relaxing area of your choice.
Provide an outlet to plug the cable. Place the infrared backrest on a bench. Make
sure that the bench is wide enough so that you can comfortably sit and lean to it
with your back. Turn the infrared emitter ON by clicking the switch. Switch OFF the
power if the heat becomes uncomfortable. Use infrared backrest for a maximum of
20 mins per session only. When using for rst time and you experience unexpected
body reaction or discomfort within 48hrs, seek for a medical attention.
MAINTENANCE
• To clean the wood: use a mild detergent and wipe with a damp cloth. Be careful
not to wet the infrared emitter. In case of stain, scrub with ne sandpaper to
regain wood’s original property.
• To clean the infrared emitter: rub with a dry cloth or use a vacuum to remove
dusts.

www.sawo.com | [email protected]
Subject to change without notice.
THERMAL SWITCH
Technical Specifications:
TOGGLE SWITCH
AC PLUG
230V 1N~
PILOT
LAMP
INFRARED
EMITTER
Code:
Power:
Size:
Weight:
Type:
Surface:
Wavelength:
Ambient:
505-IR-A | D
220-230 VAC 1N~
50/60 Hz
Max 170 W
300mm (W) x 180mm (D) x 950mm (H)
4.7 kg
Far-infrared
Fiber coated material
6000-14000nm
Max 75°C
ELECTRICAL DIAGRAM
505-IR_Backrest_ML_(En1118)