SC&T HE02EIR User manual

1
HDMI (HDBaseT) CAT5 Extender Series
ITEM NO.: HE02EI HDMI & IR CAT5 Extender over Single CAT5 Cable
HE02EI HDMI (HDBaseT) CAT5 Extender is using only one cost effective CAT5e/6 cable to
extend your HDTV display up to 60 meters at 1080p, 70 meters by CAT6a cable. With IR
function to delivers significant value to the entire home and commercial entertainment
system.
Features:
Extends HDMI and IR signal over one CAT5/5e/6 cable.
Uncompressed high definition video up to 1080p@60Hz@48bits and 3D and 4K*2K capable.
Built in IR control, IR signal could be selectable at either TX/RX side.
Max. Data Rate- 10.2Gbps.
HDMI 1.4 and HDCP compliance.
Transmission range up to 60M by CAT5e/6, 70M by CAT6a cable at 1080p@60Hz@24bit.
Audio support up to LPCM7.1, Dolby TrueHD, DTS-HD MA.
Installation view:
IR Switch Setting:
1. When use BD/DVD remote controller (DVD at remote side)，HE02EIR IR switch move
to RX and connect with Receiver cable; HE02EIT IR switch move to TX and connect
with Emitter cable.
2. When use TV remote controller (TV at remote side), HE02EIT IR switch move to RX
and connect with Receiver cable; HE02EIR IR switch move to TX and connect with
Emitter cable.
Low-power Mode:
When there is no HDMI video signal input or TV is not connected or power off, this product will enter a
low-power mode to save power consumption; under a low power mode still provides Ethernet, RS-232,
IR, and CEC of signal transmission.

2
LED Indication:
Power GREEN on (power)
Link BLUE on (linking)
Flash (low-power mode)
Cable:
Link cable recommend use high quality Cat.5e、Cat.6、Cat.6a、Cat.7 UTP / STP or FTP cable.
Poor quality cable or network connection or improper construction will cause unstable
connection, video or sound disruptions, picture noise appears.
HDBaseT Distance chart by different cable:
Cable Type
Range
Pixel Clock Rate
Video Data Rate
Supported Video
CAT.5e / CAT.6
60 M
≦225MHz
≦5.3Gbps (Full HD
Video)
1080p 60Hz 36 bit
CAT.6a / CAT.7
70 M
CAT.5e / CAT.6
35 M
> 225MHz
> 5.3Gbps (Ultra HD
Video)
1080p 60Hz 48 bit
1080p 60Hz 3D，4K x 2K 30Hz
CAT.6a / CAT.7
40 M
If connection through the wall socket, the cable length must less 5 meters between HDMI
extender and wall jack, as below drawing:
10/100Mbps network connection using general CAT5e cable and working distance up to 60M.
RJ45 Define:
Video Link (TIA/EIA-568-B)
1. Orange-white DATA0 +
2. Orange DATA0 -
3. Green-white DATA1 +
4. Blue DATA2 +
5. Blue-white DATA2 -
6. Green DATA1 -
7. Brown-white DATA3 +
8. Brown DATA3 -
Panel view:
HE02EIT HE02EIR
Transmitter
Wall Jack
Wall Jack
Receiver
CAT6a 70M
< 5M
< 5M

3
Caution:
1. The wiring must away from any equipment with electromagnetic wave, i.e.: mobile
phone, microwave, radio equipment, fluorescent lamp, high voltage power lines.
2. The cable must pull in straight to avoid any crosstalk interference and the
transmission stability.
3. This device HDBaseT port is not general Ethernet signal; do not connect with Network
devices to avoid damage.
4. IR transmitter do not put near from receiver to avoid mutual interference.
5. The receiver unit working temperature is higher which is in normal condition.
HE02EI Package Include:
HE02EIT HDM Transmitter x 1 pcs
HE02EIR HDMI Receiver x 1 pcs
IR Emitter Cable x 1 pcs
IR Receiver Cable x 1 pcs
Mounting Screw pack x 2 bags
Power Adapter x 2 pcs
Specification:
ITEM NO.
HE02EIT
HE02EIR
HDMI Video Support
Up to 1080p@60Hz@48bits,3D,4K x 2K
HDMI Audio Support
LPCM 7.1 192KHz, Dolby Trued, DTS-HD MA
Distance
60M by CAT5e/6, 70M by CAT6a
Input / Output Interface
HDMI Type A x 1
HDBaseT Connector
RJ45 x 1
IR Carrier Frequency
30-60Khz
IR Angle
± 15°
± 55°
IR Distance
5m / Bi-directional
Power Supply
DC 5V 2A
DC 5V 2A
Power Consumption
Max 3W, Low Power 0.8W
Max 6W,Low Power 1W
Temperature
Operation: 0 to 55℃, Storage: -20 TO 85℃, Humidity: up to 95%
Dimensions mm
49 x 92.3 x 25
49 x 92.3 x 25
Weight g
125
135
Rev. C