SC&T HKM02B-4K User manual

Button Instruction:
1. ON (Green) 4. MSG (Red)
On –Device ready On –Receive “Remote”Signal
Flashing –System starting up Flashing- System warning
2. LINK (Blue) 5. Display Panel
On–Link connected On Standby –Current Channel
Flashing- Trying to connect/ no input source
3. IR (Red) 6. Menu Button (Blue)
On –Receive IR signal On-Under menu selection
Button
-
+
Menu
Short Press
*Reduce
Number
*Increase
Number
Menu/Cancel
Press together
Enter
HKM02B-4K: Quick Guide
Transmitter (Tx)
Receiver (Rx)
Note: This remote can only control either Tx or Rx.
This Process only sets up the remotes.
You don’t have to point the remote to the devices.
Step 2. Plug and Use
If there are multiple systems on the same network, please make sure
each pair is on a different channel. *Default Channel “0”
Trouble Shooting
HDCP fail: Please use the receiver remote or front panel and enable
Menu 47 “HDCP always On”function on the receiver box.
(Press: Menu -> 47 -> Enter -> 1 -> Enter)
No display: Please force 1080p 60 Hz output on the receiver box by
pressing “Menu -> 40 -> Enter -> 2-> Enter”on the receiver remote
or front panel.
Make sure the Transmitter & Receiver are on the same Channel
Reset to default “Menu -> 333 -> Enter
Point to Point Application
*MSG light will light when receive remote signal
Press &○ 7at the same time
Press &○ 8at the same time
*Reduce Number: switches channel or function number down
*Increase Number: switches channel or function number up
Step 1. Setup the Remote

1. Enable IGMP V2
2. Setup Jumbo Frame 8K or above
Note: Please find the instruction on the Ethernet switch manual or see the setup example
under the trouble shooting section in the manual
Multi to Multi Application
Step 1. Setup the Remote
Transmitter (Tx)
Receiver (Rx)
Press &○ 7at the same time
Press &○ 8at the same time
Note: This remote can only control either Tx or Rx
Step 4. Connect Transmitter & Receiver to Gigabit
Mangement Switch
Step 3. Setup the Gigabit Mangement Switch
Step 5. Download the Software
PC Software: http://tiny.cc/n5gc0y
Mobile App: B&W Video Wall Control
Android IOS
Step 2. Setup the Transmitter Box to the Desired Channel
Transmitter:
Press “+”or “-“to the desired channel number and
Press “+”and “-“at the same time to confirm (enter)
# Each Transmitter has to be on a different Channel
Receiver:
Press “+”or “-“to the desired channel number and
Press “+”and “-“at the same time to confirm (enter)