// 7
ENGLISH / Connecting your loudspeakers
We recommend that you read the manual of your amplifier or av-receiver carefully before connecting
your MicroPod SE loudspeakers. Please switch off all equipment when connecting MicroPod SE.
The binding posts on the terminal
accepts wire up to Ø 4mm or cables
with bananaplugs.
Make sure that the positive terminal
binding posts on MicroPod SE (+) are
connected to the positive output
terminal binding posts on the ampli-
fier and that the negative terminals
on MicroPod SE (-) are connected to
the negative output terminal on the
amplifier.
You are now ready to enjoy the great sound of MicroPod SE.
ENGLISH / Running-in period
We recommend a running-in period of your new MicroPod SE loudspeaker of approximately 15-20 hours at normal listening level before you decide on the
final positioning of the loudspeaker. During the running-in period, the drive units will settle in and perform as intended.
ENGLISH / Care and cleaning
We strongly advise against the use of any solvents or cleaners on the lacquered MicroPod SE cabinet. The cabinet surface usually only requires dusting or
cleaning with a damp soft cloth (only use cold clean water). Avoid touching the drive units, especially the tweeter, as damage may result.
ENGLISH / Environmental information
MicroPod SE complies with international directives on the Restriction of Hazardous Substances (RoHS) in electrical and electronic equipment and the
disposal of Waste Electrical and Electronic Equipment (WEEE) - the crossed bin symbol indicates compliance and that the products must be appropriately
recycled or processed in accordance with these directives.
ENGLISH