IM022
www.scarlett.ru SC-HC63C57
Do not put operating appliance on any surface, it may cause
injury or damage.
Do not use the appliance with damaged comb, or with teeth
missing from the blades as injury may occur.
NOTE: KEEP THE BLADES OILED.
The appliance should be used only with the power supply
supplied with the appliance.
The instrument must be powered only by a safe, ultra-low
voltage marked on the instrument.
Do not use the hair clipper when the skin is infected.
Do not use the hair clipper on animals.
If the product has been exposed to temperatures below 0ºC for some time it should be kept at
room temperature for at least 2 hours before turning it on.
The manufacturer reserves the right to introduce minor changes into the product design
without prior notice, unless such changes influence significantly the product safety,
performance, and functions.
Manufacturing date is indicated on the unit and/or on packing as well as in accompanying
documents in the following format XX.XXXX where first two figures XX is the month of
production, and following four figures XXXX is the year of production.
PREPARATION
The device is designed for cutting hair.
Before first use cutting blades of the machine should be thoroughly lubricated.
Before switching the unit on for the first time, please fully discharge and recharge the battery.
The charging time is 8 hours.
The fully charged battery ensures 45 minutes of operation.
Recharge the battery at least once in 6 months, even if the clipper is not in use.
To charge the battery, switch off the clipper and connect its power cord to mains. The indicator
lamp lights.
When the battery has charged, disconnect the clipper from mains. The clipper is ready for
operation.
OPERATION
You may operate the clipper, when its battery is charged, or if it is connected to the mains.
Take one of the supplied combs, insert the comb guides into the matching slots and gently
push until it clicks.
Turn the length of the hair cutting at the rear of the machine, set the desired length.Turn the
knob until the desired length is the figure does not coincide with the mark on the housing.
To turn on the machine, slide the switch up.
When finished, turn off the machine by moving the switch down.
You may also use the clipper without any comb attached.
THINNING FUNCTION
The blade allows you to use thinning function and improve quality of cutting.
Thinning allows to make smooth passage between hair strands of different length. In this
mode the blade reduces hair volume without making the hair shorter.
BLADE ATTACHMENT
To detach the blade from the appliance, press it and pull it forward.
To attach the blade, insert it into place and push until the click is heard.
REPLACEMENT OF THE COMB ATTACHMENT
Turn off the device.
Gently pull the comb up.
Install the comb on top of the cutting block so that the attachment clips fit into the special slots
located on the sides.
REMINDERS
It is better to cut dry hair.
Comb hair carefully before cutting.
