Sealey LED098 User manual

INSTRUCTIONS FOR
TELESCOPIC FLOODLIGHT 10W SMD LED
230V
MODEL NO: LED098
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. Electrical Safety
WARNING! It is the user’s responsibility to check the following:
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical
products. You may obtain an RCD by contacting your local Sealey dealer.
 iftheoodlightisusedinthecourseofbusinessduties,itmustbemaintainedinasafeconditionandroutinelyPAT(Portable 
 ApplianceTest)tested.
9Electrical safety information, it is important that the following information is read and understood.
9Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
9regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
9Ensurethatthevoltageratingontheappliancesuitsthepowersupplytobeusedandthattheplugisttedwiththecorrectfuse.
8DO NOT pull or carry the appliance by the power cable.
8DO NOT pull the plug from the socket by the cable.
8DO NOT use worn or damaged cables, plugs or connectors.
9 ThisproductisttedwithaBS1363/A13Amp3pinplug.Ifthecableorplugisdamagedduringuse,switchtheelectricitysupplyand
 removefromuse.Repairsmustbecarriedoutbyaqualiedelectrician.
 ReplaceadamagedplugwithaBS1363/A13Amp3pinplug.
 a)ConnecttheGREEN/YELLOWearthwiretotheearthterminal‘E’.
 b)ConnecttheBROWNlivewiretotheliveterminal‘L’.
 c)ConnecttheBLUEneutralwiretotheneutralterminal‘N’.
Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
 Sealeyrecommendthatrepairsarecarriedoutbyaqualiedelectrician.
1.2. General Safety
WARNING! Turn off the mains power supply before servicing or performing any maintenance.
9Ensure the light is installed correctly in accordance with these instructions.
9If you use an extension lead the cable must be fully unwound from the drum.
▲DANGER! DO NOT directthelightintoaperson’seyes.Allmodelshaveaveryintenselightoutputwhich,if 
incorrectly used, could cause eye damage.
8DO NOT use the light without the front glass shield.
8DO NOTusethelightnearammable,combustibleorexplosiveliquids,solids,gasesorequipment.
9 Maintainthelightingoodcondition.Repairsmustonlybeundertakenbyaqualiedelectrician(useanauthorisedserviceagent).
9Locate the light in an adequate area for its function, keep area clean and tidy and free from unrelated materials.
9 Whennotinuse,switchoffthelightanddisconnectfromthepowersupply.Ensurethattheunitiscoolanddryand
then store in a safe, dry, childproof area.
8DO NOT install the light where it is likely to be knocked or hit.
8DO NOT install in bathrooms, shower rooms, sauna or such locations.
2. INTRODUCTION
Floodlight with die-cast powder coated aluminium extra slim housing mounted on a tripod with folding legs. SMD LED technology allows ultra
brightilluminationwhilststillkeepingcostslowerthantraditionalhalogentubes.Evenspreadoflightacrossa110°angle.SuppliedwithBS
approved13Aplug.
LED098|Issue220/12/16
Original Language Version
© Jack Sealey Limited
Recommended fuse rating
3Amp
Electrical
shock
hazard
Refer to
instructions

3. SPECIFICATION
Model No................................................................... LED098
Power..............................................................................10W
LED Quantity...................................................................... 12
Lumen Output .............................................................. 800lm
Supply............................................................................230V
Min/MaxHeight .................................................... 0.61/1.6mtr
Colour Temperature .....................................................6000K
IPRating .........................................................................IP54
4. OPERATION
4.1.  Extendtripodlegstofullextentg.1.Adjustheightasrequiredbyreleasingscrewclampson
telescopic pole, re-tighten clamps at desired height.
4.2.  Positionthefloodlightintheareathatrequiresillumination,adjustinglampangleasrequired.
4.3. ThisLEDfloodlightdevelopsminimalheatandisnotsubjecttothesamerestrictionsthatapply
 tohalogenlampsthatbecometoohottotouch.Wedohoweverrecommendthattheoodlight
should not be placed in cramped or restrictive situations and recommend the following minimum
 distancesbetweenthelightandanysurface/object.
  ●500mmminimumbetweenthetopofthelightandanyoverheadsurface,orobjects.
  ●200mmbetweensidesoflightandendorsidewalls,surfacesorobjects.
 ●1metreminimumbetweenthefrontofthelightandanyobjecttobeilluminated.
4.4.  Plugthelightintothepowersupplyandswitchon.
WARNING! Ensure the light is disconnected from the mains power supply when not in use
9Ensure that the unit is cool and dry and is stored in a cool, dry, childproof area.
5. MAINTENANCE
5.1. Clean the casing externally (not the glass) with a moist cloth.
8DO NOT use solvents or abrasives.
5.2. If necessary clean the glass with alcohol and a soft cloth.
Original Language Version
© Jack Sealey Limited
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
SoleUKDistributor,SealeyGroup.
KempsonWay,SuffolkBusinessPark,
Bury St. Edmunds, Suffolk.
IP327AR
www.sealey.co.uk
[e-mail]
01284757500
01284703534
Web
Environmental Protection
Recycleunwantedmaterialsinsteadofdisposingofthemaswaste.Alltools,accessoriesandpackagingshouldbesorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
WEEE Regulations
DisposeofthisproductattheendofitsworkinglifeincompliancewiththeEUDirectiveonWasteElectricalandElectronic
Equipment(WEEE).Whentheproductisnolongerrequired,itmustbedisposedofinanenvironmentallyprotectiveway.
Contact your local solid waste authority for recycling information.
Parts support is available for this product,
please log on to www.sealey.co.uk, email [e-mail] or telephone [phone].
g.1
LED098|Issue220/12/16