Sealey HT102R User manual

3W CREE USB HEAD TORCH WITH SENSOR
MODEL NO: HT102R
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. General
8DO NOT shine directly into your, another person’s or an animal’s eyes.
8DO NOT allow children to use the torch.
8DO NOT use the torch if you suspect that the battery or the torch casing is damaged.
8DO NOT leave batteries in a discharged state. Before storage remove batteries.
1.2. Battery Safety
WARNING! To reduce the risk of burns or re:
8DO NOT attempt to open the batteries.
8DO NOT crush, puncture, short contacts or dispose of in re or water.
8DO NOT expose to temperatures above 60°C (140°).
9Replace only with the batteries designed for this product.
9Recycle or dispose of used batteries as stipulated by local regulation.
9If the electrolyte in the batteries gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly
with cool water and seek immediate medical attention.
2. INTRODUCTION
Hands-free head torch with adjustable 3W CREE XPE LED spotlight to direct light as required. One switch features an auto sensor to activate
light with the wave of a hand and standard on/o󰀨 switch. Produces up to 120 lumens. Other switch has three power options of full, 30% energy
saving mode, ash and red light. Powered by a rechargeable 3.7V 1.2Ah Li-ion battery. Supplied with micro USB charging lead.
3. SPECIFICATION
Model No: .................................................................HT102R
LED Qty: ........................................................3W CREE XPE
Lumen Output: ............................................................. 120lm
Battery: .......................................................3.7V 1.2Ah Li-ion
Charging Time:..................................................................4hr
Nett Weight: ..................................................................... 84g
4. OPERATION
4.1. Charging: Connect the USB lead to the port on the bottom of the head torch (g.2). The LED indicator will show red whilst the battery
is charging and green when the battery is fully charged (g.3).
4.2. Main Beam: Press on/o󰀨 switch once for full beam, twice for a dipped beam, third time for ashing and forth to turn o󰀨.
4.3. Red lights: Holding down the on/o󰀨 switch for 3 seconds will turn on the red lights
4.4. Motion Activated Light: Press the motion sensor button to enable this function. A blue light will show on top of the torch when the
sensor is activated. You will now be able to turn the torch on and o󰀨 by waving your hand in front of the sensor.
g.1
g.2 g.3
HT102R | Issue 1 03/05/18
Original Language Version
© Jack Sealey Limited
Refer to
instructions

5. MAINTENANCE
5.1. Keep the torch clean by wiping with a damp cloth.
5.2. Store torch in a dry childproof area.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
HT102R | Issue 1 03/05/18
Original Language Version
© Jack Sealey Limited